(Ag)Pd-Fe3O4 Nanocomposites as Novel Catalysts for Methane Partial Oxidation at Low Temperature
Open Access
- 21 May 2020
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 10 (5) , 988
Abstract
Nanostructured composite materials based on noble mono-(Pd) or bi-metallic (Ag/Pd) particles supported on mixed iron oxides (II/III) with bulk magnetite structure (Fe3O4) have been developed in order to assess their potential for heterogeneous catalysis applications in methane partial oxidation. Advancing the direct transformation of methane into value-added chemicals is consensually accepted as the key to ensuring sustainable development in the forthcoming future. On the one hand, nanosized Fe3O4 particles with spherical morphology were synthesized by an aqueous-based reflux method employing different Fe (II)/Fe (III) molar ratios (2 or 4) and reflux temperatures (80, 95 or 110 °C). The solids obtained from a Fe (II)/Fe (III) nominal molar ratio of 4 showed higher specific surface areas which were also found to increase on lowering the reflux temperature. The starting 80 m2 g−1 was enhanced up to 140 m2 g−1 for the resulting optimized Fe3O4-based solid consisting of nanoparticles with a 15 nm average diameter. On the other hand, Pd or Pd-Ag were incorporated post-synthesis, by impregnation on the highest surface Fe3O4 nanostructured substrate, using 1–3 wt.% metal load range and maintaining a constant Pd:Ag ratio of 8:2 in the bimetallic sample. The prepared nanocomposite materials were investigated by different physicochemical techniques, such as X-ray diffraction, thermogravimetry (TG) in air or H2, as well as several compositions and structural aspects using field emission scanning and scanning transmission electron microscopy techniques coupled to energy-dispersive X-ray spectroscopy (EDS). Finally, the catalytic results from a preliminary reactivity study confirmed the potential of magnetite-supported (Ag)Pd catalysts for CH4 partial oxidation into formaldehyde, with low reaction rates, methane conversion starting at 200 °C, far below temperatures reported in the literature up to now; and very high selectivity to formaldehyde, above 95%, for Fe3O4 samples with 3 wt.% metal, either Pd or Pd-Ag.Keywords
Funding Information
- Comunidad de Madrid (2017-T1/IND-6025)
This publication has 83 references indexed in Scilit:
- Direct Catalytic Conversion of Methane to Methanol in an Aqueous Medium by using Copper‐Promoted Fe‐ZSM‐5Angewandte Chemie International Edition, 2012
- Direct Conversion of Methane into Formaldehyde Mediated by [Al2O3].+ at Room TemperatureAngewandte Chemie International Edition, 2012
- Vibrational Spectroscopic Characterization of Hematite, Maghemite, and Magnetite Thin Films Produced by Vapor DepositionACS Applied Materials & Interfaces, 2010
- Selective oxidation of methane to formaldehyde by oxygen over silica-supported iron catalystsJournal of Natural Gas Chemistry, 2009
- Catalytic partial oxidation of methane to formaldehydeRussian Journal of Applied Chemistry, 2009
- One step grafting of monomethoxy poly(ethylene glycol) during synthesis of maghemite nanoparticles in aqueous mediumColloids and Surfaces A: Physicochemical and Engineering Aspects, 2008
- Heated goethite and natural hematite: Can Raman spectroscopy be used to differentiate them?Vibrational Spectroscopy, 2007
- Reduction behavior of iron oxides in hydrogen and carbon monoxide atmospheresApplied Catalysis A: General, 2007
- Carbon pathways for the partial oxidation of methaneThe Journal of Physical Chemistry, 1993
- Partial Oxidation of MethaneCatalysis Reviews, 1986