Design and Implementation of a Parallel-Connected Fault Current Attenuator for Power Distribution Systems
- 17 May 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 10 (1) , 402-412
Abstract
Parallel-connected fault current attenuator (PFCA) is a novel concept for active reduction of short-circuit currents through circuit breakers in power distribution grids. The sustained increase in the short-circuit currents could exceed the rating of the circuit breakers, dangerously spreading the fault. Several series-connected schemes to reduce these high currents, such as fault current limiters and series reactors have been proposed in recent decades. This paper designs and experimentally verifies the feasibility of a parallel-connected power converter to reduce the short-circuit currents, operating as a controlled current source by absorbing current from the fault point. This new configuration reduces the short-circuit currents in all circuit breakers of an electrical substation. The proposed parallel-connected fault current attenuator is implemented using a single-phase neutral-point clamped (NPC) converter and tested using a predictive current control scheme for short-circuits in a scaled-down power system. The experimental results prove the effectiveness of the proposed scheme, reducing significantly the first short-circuit current peak, even when the AC bus voltage is close to zero.Keywords
Funding Information
- Comisión Nacional de Investigación Científica y Tecnológica (CONICYT)/PCHA/Doctorado Nacional (2015-21151619)
- Solar Energy Research Center (ANID/FONDAP/15110019)
- Agencia Nacional de Investigación y Desarrollo (ANID)/FONDEQUIP (140148)
This publication has 25 references indexed in Scilit:
- Optimal location and minimum number of superconducting fault current limiters for the protection of power gridsInternational Journal of Electrical Power & Energy Systems, 2017
- Optimal Location and Sizing of Fault Current Limiters in Mesh Networks Using Iterative Mixed Integer Nonlinear ProgrammingIEEE Transactions on Power Systems, 2016
- A Review of Passive Power Filters for Three-Phase Grid-Connected Voltage-Source ConvertersIEEE Journal of Emerging and Selected Topics in Power Electronics, 2015
- LCL Filter Design and Inductor Current Ripple Analysis for a Three-Level NPC Grid Interface ConverterIEEE Transactions on Power Electronics, 2014
- Influence of fault type on the optimal location of superconducting fault current limiter in electrical power gridInternational Journal of Electrical Power & Energy Systems, 2014
- Probabilistic Evaluation of Substation Criticality Based on Static and Dynamic System PerformancesIEEE Transactions on Power Systems, 2013
- Analysis of dc‐link capacitor current in three‐level neutral point clamped and cascaded H‐bridge invertersIET Power Electronics, 2013
- Discrete Nonlinear Control based on a double dq Transform of a Multi-Cell UPQC2011
- Harmonic analysis: Comparison between different modulation strategies for three phase inverter connecting Distributed Generation2011
- A Series Compensator With Fault Current Limiting FunctionIEEE Transactions on Power Delivery, 2005