A Dual-Slope Capacitance-to-Digital Converter Integrated in an Implantable Pressure-Sensing System
- 11 June 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 50 (7) , 1581-1591
Abstract
A dual-slope capacitance-to-digital converter for pressure-sensing is presented and demonstrated in a complete microsystem. The design uses base capacitance subtraction with a configurable capacitor bank to narrow down input capacitance range and reduce conversion time. An energy-efficient iterative charge subtraction method is proposed, employing a current mirror that leverages the 3.6 V battery supply available in the system. We also propose dual-precision comparators to reduce comparator power while maintaining high accuracy during slope conversion, further improving energy efficiency. The converter occupies 0.105 mm 2 in 180 nm CMOS and achieves 44.2 dB SNR at 6.4 ms conversion time and 110 nW of power, corresponding to 5.3 pJ/conv-step FoM. The converter is integrated with a pressure transducer, battery, processor, power management unit, and radio to form a complete 1.4 mm × 2.8 mm × 1.6 mm pressure sensor system aimed at implantable devices. The multi-layer system is implemented in 180 nm CMOS. The system was tested for resolution in a pressure chamber with an external 3.6 V supply and serial communication bus, and the measured resolution of 0.77 mmHg was recorded. We also demonstrated the wireless readout of the pressure data on the stack system operating completely wirelessly using an integrated battery.Keywords
This publication has 16 references indexed in Scilit:
- Chronically Implanted Pressure Sensors: Challenges and State of the FieldSensors, 2014
- Dual-slope capacitance to digital converter integrated in an implantable pressure sensing system2014
- A 6.3 µW 20 bit Incremental Zoom-ADC with 6 ppm INL and 1 µV OffsetIEEE Journal of Solid-State Circuits, 2013
- A 1.2-V 8.3-nJ CMOS Humidity Sensor for RFID ApplicationsIEEE Journal of Solid-State Circuits, 2013
- Analog-to-Digital Conversion2013
- A Portable 2-Transistor Picowatt Temperature-Compensated Voltage Reference Operating at 0.5 VIEEE Journal of Solid-State Circuits, 2012
- A fully-digital, 0.3V, 270 nW capacitive sensor interface without external references2011
- Simulation and Analysis of Random Decision Errors in Clocked ComparatorsIEEE Transactions on Circuits and Systems I: Regular Papers, 2009
- A Current-Mode, Dual Slope, Integrated Capacitance-to-Pulse Duration ConverterIEEE Journal of Solid-State Circuits, 2007
- Design-oriented estimation of thermal noise in switched-capacitor circuitsIEEE Transactions on Circuits and Systems I: Regular Papers, 2005