Architecture of the Interface between the Perovskite and Hole‐Transport Layers in Perovskite Solar Cells
- 1 September 2016
- journal article
- research article
- Published by Wiley in ChemSusChem
- Vol. 9 (18) , 2634-2639
Abstract
The interface between the perovskite (PVK, CH3NH3PbI3) and hole‐transport layers in perovskite solar cells is discussed. The device architecture studied is as follows: F‐doped tin oxide (FTO)‐coated glass/compact TiO2/mesoporous TiO2/PVK/2,2′,7,7′‐tetrakis‐(N,N‐di‐4‐methoxyphenylamino)‐9,9′‐spirobifluorene (Spiro‐MeOTAD)/Au. After a thin layer of 4,4,4‐trifluorobutylammonium iodide (TFBA) was inserted at the interface between PVK and Spiro‐MeOTAD, the photovoltaic efficiency increased from 11.6–14.5 % to 15.1–17.6 %. TFBA (10 ppm) was added in the PVK solution before coating. Owing to the low surface tension of TFBA, TFBA rose to the surface of the PVK layer spontaneously during spin‐coating to make a thin organic layer. The PVK grain boundaries also seemed to be passivated with the addition of TFBA. However, large differences in Urbach energies and valence band energy level were not observed for the PVK layer with and without the addition of TFBA. The charge recombination time constant between the PVK and the Spiro‐MeOTAD became slower (from 8.4 to 280 μsec) after 10 ppm of TFBA was added in the PVK. The experimental results using TFBA conclude that insertion of a very thin layer at the interface between PVK and Spiro‐MeOTAD is effective for suppressing charge recombination and increasing photovoltaic performances.Keywords
Funding Information
- CREST project in Japan
This publication has 24 references indexed in Scilit:
- Perovskite solar cells with a planar heterojunction structure prepared using room-temperature solution processing techniquesNature Photonics, 2013
- Perovskites: The Emergence of a New Era for Low-Cost, High-Efficiency Solar CellsThe Journal of Physical Chemistry Letters, 2013
- Efficient planar heterojunction perovskite solar cells by vapour depositionNature, 2013
- Sequential deposition as a route to high-performance perovskite-sensitized solar cellsNature, 2013
- Low-temperature processed meso-superstructured to thin-film perovskite solar cellsEnergy & Environmental Science, 2013
- Chemical Management for Colorful, Efficient, and Stable Inorganic–Organic Hybrid Nanostructured Solar CellsNano Letters, 2013
- Efficient Hybrid Solar Cells Based on Meso-Superstructured Organometal Halide PerovskitesScience, 2012
- Lead Iodide Perovskite Sensitized All-Solid-State Submicron Thin Film Mesoscopic Solar Cell with Efficiency Exceeding 9%Scientific Reports, 2012
- Multiple electron injection dynamics in linearly-linked two dye co-sensitized nanocrystalline metal oxide electrodes for dye-sensitized solar cellsPhysical Chemistry Chemical Physics, 2012
- The Long-Wavelength Edge of Photographic Sensitivity and of the Electronic Absorption of SolidsPhysical Review B, 1953