Testing of a 40-kWth Counterflow Particle-Supercritical Carbon Dioxide Narrow-Channel, Fluidized Bed Heat Exchanger
Open Access
- 19 February 2024
- journal article
- research article
- Published by TIB Open Publishing in SolarPACES Conference Proceedings
- Vol. 1
Abstract
Particle-based primary heat exchangers (HXs) must deliver sCO2 fluid temperatures above 700°C to couple particle-based concentrating solar receivers and thermal energy storage (TES) sub-systems with efficient sCO2 power cycles. Particle-sCO2 HX designs have struggled to meet DOE cost targets (≤ $150/kWth) due to the amount of expensive nickel alloys necessary for manufacturing full-scale, particle-sCO2 HXs. Our team has demonstrated that mild bubbling fluidization of falling particles in a counterflow narrow-channel fluidized bed can reduce required HX surface area and thus, costs by increasing particle-wall heat transfer coefficients hT,w > 800 W m-2 K-1. This paper reports on the fabrication and testing of a stainless steel, particle-sCO2 HX with 12 fluidized-bed channels approximately 10.5 mm deep spaced between diffusion-bonded, micro-channel sCO2 plates. The HX with a core length of ≈0.56 m is fed with CARBOBEAD HSP particles through a short, fluidized freeboard zone just above the core. Testing to date in the National Solar Thermal Test Facility (NSTTF) at Sandia National Laboratories has shown that parallel bed fluidization maintains uniform particle inventory across the instrumented channels. Heat transfer thermal duty between the particle and sCO2 flows exceeds 30 kWth with sCO2 inlet temperatures of 200ºC and particle inlet temperatures up to 440ºC and mass flow rates of 0.2 kg s-1 fluidized by counterflowing gas flow rates of 0.005 kg s-1. Tests at higher particle and sCO2 inlet temperatures (600ºC and 400ºC respectively) are targeted to achieve > 40 kWth with model-predicted overall heat transfer coefficients U > 400 W m-2 K-1.Keywords
Funding Information
- Solar Energy Technologies Office (DE-EE0008538)
This publication has 11 references indexed in Scilit:
- Narrow-channel fluidized beds for particle-sCO2 heat exchangers in next generation CPS plants2022
- Modeling and parameter sensitivity analysis of fluidized bed solid particle/sCO2 heat exchanger for concentrated solar power plantApplied Thermal Engineering, 2021
- Testing and model validation of a prototype moving packed-bed particle-to-sCO2 heat exchangerAIP Conference Proceedings, 2020
- Design and operating considerations for a shell-and-plate, moving packed-bed, particle-to-sCO2 heat exchangerSolar Energy, 2019
- Heat transfer in counterflow fluidized bed of oxide particles for thermal energy storageInternational Journal of Heat and Mass Transfer, 2018
- Dynamic simulation of an electric arc furnace waste heat recovery system for steam productionApplied Thermal Engineering, 2018
- Concentrating Solar Power Gen3 Demonstration Roadmap2017
- Technoeconomic Analysis of Alternative Solarized s-CO2 Brayton Cycle ConfigurationsJournal of Solar Energy Engineering, 2016
- Moving Bed Heat Exchangers for Use With Heat Storage in Concentrating Solar Plants: A Multiphase ModelHeat Transfer Engineering, 2013
- Heat transfer in gas fluidized beds part 2. Dependence of heat transfer on gas velocityPowder Technology, 1992