Mullite Alumina Particulate Composites by Infiltration Processing: II, Infiltration and Characterization
Authors:
- 1 December 1990
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 73 (12) , 3611-3616
Abstract
Mullite/alumina composites were fabricated by infiltrating porous alumina preforms with a hydrolyzed ethyl silicate sol. Evidence is presented which suggests that initial infiltration occurred without complete filling of the porosity by the sol. Multiple infiltrations were used to increase the amount of SiO 2 introduced but led to blockage of the pores in the surface of the preform. Sintered bodies had concentration gradients, SiO 2 decreasing from the surface inward. Although mullite limited grain growth in alumina, in partially modified bodies large grains (>1 mm) with a preferred orientation were observed at the interface between the two zones.Keywords
This publication has 8 references indexed in Scilit:
- ChemInform Abstract: Mullite/Alumina Particulate Composites by Infiltration Processing.ChemInform, 1990
- Mullite/Alumina Particulate Composites by Infiltration ProcessingJournal of the American Ceramic Society, 1989
- Incorporation of Mullite as a Second Phase into Alumina by an Infiltration TechniqueJournal of the American Ceramic Society, 1988
- Melt Infiltration Approach to Ceramic Matrix CompositesJournal of the American Ceramic Society, 1988
- Ceramic Matrix Composites by Means of Melt Infiltration1987
- Hindrance of Grain Growth in Al 2 O 3 by ZrO 2 Inclusions.Journal of the American Ceramic Society, 1984
- Phase Relations in the System Na2O‐TiO2‐SiO2Journal of the American Ceramic Society, 1979
- The Dynamics of Capillary FlowPhysical Review B, 1921