Experimental Research of Diffusion Combustion and Emissions Characteristics Under Oxy-Fuel Combustion Mode
- 21 May 2020
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 142 (6)
Abstract
Internal combustion Rankine cycle (ICRC) concept implements oxy-fuel combustion, direct water injection (DWI), and waster heat recovery (WHR) into traditional Otto or diesel cycle to realize high thermal efficiency and low emission powertrain. In order to support ICRC realization, this paper is dedicated to investigate the feasibility of implementing oxy-fuel combustion into diffusion combustion which provides fundamental information for future compression ignition (CI)-ICRC engine. The prototype oxy-fuel diffusion combustion engine test bench is established based on a retrofitted diesel engine, and the O2/CO2 mixture intake system, high-pressure common rail fuel injection system, and high-performance electronic controller are designed and installed within engine test bench to investigate the combustion and emission characteristics under different intake oxygen fractions (OF), fuel injection durations, and fuel injection timing. The optimum intake OF and fuel injection strategies are acquired within the selected experimental conditions, a 41.1% brake thermal efficiency (BTE), and 1.2% coefficient of variation (CoV) is achieved utilizing 55% intake OF, 0.7 ms fuel injection duration and 352 °CA (after exchange top dead center (TDC)) fuel injection timing. The oxy-fuel diffusion combustion proved to be a feasible solution for simultaneously reduction in NOX and particulate emissions, and NOX emissions lower than 90 × 10−6 with particulate matters (PM) around 0.1 filter smoke number (FSN) is observed during engine bench testing. The result of this study provides fundamental information for future CI-ICRC prototype engine establishment and optimization, which also could be utilized as reference guidance for potential industrialization of internal combustion engine (ICE) with oxy-fuel combustion mode.Keywords
Funding Information
- Fundamental Research Funds for the Central Universities (2019CDXYQC0002)
- National Natural Science Foundation of China (91441125 and U1832179)
This publication has 20 references indexed in Scilit:
- The chemical mechanism of the effect of CO2 on the temperature in methane oxy-fuel combustionInternational Journal of Heat and Mass Transfer, 2015
- An overview of current status of carbon dioxide capture and storage technologiesRenewable and Sustainable Energy Reviews, 2014
- A high efficiency oxyfuel internal combustion engine cycle with water direct injection for waste heat recoveryEnergy, 2014
- Experimental study of the effect of water injection on the cycle performance of an internal-combustion Rankine cycle engineProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2014
- Numerical simulation on combustion processes of a diesel engine under O2/CO2 atmosphereHKIE Transactions, 2013
- Experimental Study of the Failure Modes of the Methanol-ignition Engine KnockJournal of Mechanical Engineering, 2013
- Oxy-fuel coal combustion—A review of the current state-of-the-artInternational Journal of Greenhouse Gas Control, 2011
- Oxy-fuel combustion of solid fuelsProgress in Energy and Combustion Science, 2010
- Carbon Capture for Automobiles Using Internal Combustion Rankine Cycle EnginesJournal of Engineering for Gas Turbines and Power, 2009
- Oxy-fuel combustion technology for coal-fired power generationProgress in Energy and Combustion Science, 2005