A new technique to separate conodont elements from heavier minerals
- 1 January 1999
- journal article
- research article
- Published by Taylor & Francis in Alcheringa: An Australasian Journal of Palaeontology
- Vol. 23 (1) , 57-62
Abstract
The density of conodont elements is between 2.90 g cm-3 and 3.04 g cm-3, probably very close to 3.00. Removing all traces of dolomite and calcium carbonate before density separation keeps the viscosity of sodium polytungstate solution low enough to make it useful for density separations as high as 3.04 g cm-3. In most cases, a nearly clean phosphatic fraction can be produced by adding this method to existing standard techniques. The oxidizing technique to remove pyrite is also discussed. In all kinds of physical concentration work consideration of the “bulk density” is very important for good results, especially regarding coniforms.Keywords
This publication has 6 references indexed in Scilit:
- A buffered formic acid technique for conodont extractionJournal of Paleontology, 1995
- Non-toxic low-cost heavy liquid separation in the Geological Survey of GreenlandRapport Grønlands Geologiske Undersøgelse, 1989
- A cryogenic density separation technique for conodont and heavy mineral separationsJournal of Paleontology, 1989
- The use of sodium polytungstate for conodont separationsJournal of Micropalaeontology, 1988
- Sodium metatungstate: a new heavy-mineral separation medium for the extraction of conodonts from insoluble residuesJournal of Paleontology, 1988
- A nontoxic heavy liquid and inexpensive filters for separation of mineral grainsJournal of Sedimentary Research, 1987