Analysis of pulsating flow measurement of engine exhaust by a Pitot tube flowmeter
Authors:
- 1 February 2005
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 6 (1) , 85-93
Abstract
The Pitot tube flowmetering technique has been used to measure pulsating flow from a vehicle engine exhaust. In general, flowmetering techniques that utilize differential pressure measurements based on Bernoulli's theory are likely to show erroneous readings when measuring an average flowrate of pulsating flow. The primary reason for this is the non-linear relationship between the differential pressure and the flowrate; i.e. the flowrate is proportional to the square root of the differential pressure. Therefore, an average of the differential pressure does not give an average of pulsating flow. In this study, fast response pressure transducers have been used to measure the pulsating pressure. Then the pulsating differential pressure is converted to the flowrate while keeping the pulsation unaveraged. An average flowrate is then calculated in the flowrate domain in order to maintain linearity before and after averaging. The peak amplitude of a pulsation measured here was about 1800 L/min at an average flowrate of 70 L/min when the engine ran at idle speed. This measurement has been confirmed by measuring the pulsation with a gas analyser. The results show a large amount of back and forth gas movement in the exhaust tube. This magnitude of pulsation can cause as much as five times higher erroneous results with the pressure domain averaging when compared to a flowrate domain averaging.Keywords
This publication has 12 references indexed in Scilit:
- Development of hydrocarbon analyzer using heated-NDIR method and its application to on-board mass emission measurement systemJSAE Review, 2003
- DVE - Direct Vehicle Exhaust Flow Measurement using Head-type FlowmetersSAE International Journal of Advances and Current Practices in Mobility, 2003
- Evaluation of Improved Bag Mini-Diluter System for Low Level Emissions Measurements2002
- Development of a Wet-based NDIR and Its Application to On-board Emission Measurement SystemSAE International Journal of Advances and Current Practices in Mobility, 2002
- Advanced Emissions Test Site for Confident PZEV MeasurementsSAE International Journal of Advances and Current Practices in Mobility, 2002
- Evaluation of the Bag Mini-Diluter and Direct Vehicle Exhaust Volume System for Low Level Emissions MeasurementSAE International Journal of Advances and Current Practices in Mobility, 2000
- Improved Bag Mini-Diluter Sampling System for Ultra-Low Level Vehicle Exhaust EmissionsSAE International Journal of Advances and Current Practices in Mobility, 2000
- A New Proportional Collection System for Extremely Low Emission Measurement in Vehicle ExhaustSAE International Journal of Advances and Current Practices in Mobility, 1999
- Numerical Analysis of Mass Emission Measurement Systems for Low Emission VehiclesSAE International Journal of Advances and Current Practices in Mobility, 1999
- Errors of an Indicator Due to a Connecting PassageTransactions of the Japan Society of Mechanical Engineers, 1964