Internally Pressurized Machined Domed Ends—a Comparison of the Plastic Buckling Predictions of the Deformation and Flow Theories
Authors:
- 1 May 1990
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 204 (3) , 169-186
Abstract
The present series of tests, involving six machined steel torispherical shells subjected to internal pressure, was designed to highlight the difference in the buckling predictions of the deformation and the flow theories of plasticity. For the geometries selected, deformation theory predicted that bifurcation buckling would occur for all the domes tested, whereas flow theory predicted buckling in only two of them. In the tests, low-amplitude waves (detected by probes) appeared in all six of the domes. In four of the domes, the low-amplitude waves grew with increasing pressure and became buckles which were visible to the naked eye. Assuming that the occurrence of low-amplitude waves can be considered as buckling of a dome, then deformation theory predicted the failure mode correctly in all six cases. Flow theory was correct in only two cases. The agreement between the initial experimental buckling pressures and those predicted by deformation theory was reasonably good, the ratios varying between 0.71 and 0.94. For three of the domes, the buckling pressures were also found by the Southwell plot technique. These latter agreed best with the deformation theory predictions. The shell buckling program used for analysis purposes was BOSOR 5 and its predictions were checked using five other independent shell buckling programs. One reason for the incorrect prediction of the failure mode by flow theory may be the neglect of initial geometric imperfections in the analysis. Some preliminary calculations including them seem to confirm the hypothesis.Keywords
This publication has 16 references indexed in Scilit:
- Experimental Tests on Buckling of Torispherical Heads and Methods of Plastic Bifurcation AnalysisJournal of Pressure Vessel Technology, 1986
- Pressure testing of large-scale torispherical heads subject to knuckle bucklingInternational Journal of Pressure Vessels and Piping, 1986
- Berechnung einer ringversteiften Rotationsschale mit VorbeulenChemie Ingenieur Technik, 1986
- The Buckling of Fabricated Torispherical Shells Under Internal Pressure1982
- Plastic Buckling of Torispherical and Ellipsoidal Shells Subjected to Internal PressureProceedings of the Institution of Mechanical Engineers, 1981
- Elastic-Plastic Buckling of Internally Pressurized Thin Torispherical ShellsJournal of Pressure Vessel Technology, 1979
- Elastic plastic buckling of internally pressurized torispherical vessel headsNuclear Engineering and Design, 1978
- Experiments on the buckling under internal pressure of thin torispherical ends of cylindrical pressure vesselsInternational Journal of Mechanical Sciences, 1978
- B0S0R5—program for buckling of elastic-plastic complex shells of revolution including large deflections and creepComputers & Structures, 1976
- The failure of torispherical ends of pressure vessels due to instability and plastic deformation—An experimental investigationInternational Journal of Mechanical Sciences, 1975