Drying kinetics of cotton based yarn bobbins in a pressurized hot-air convective dryer
- 3 August 2016
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
- Vol. 231 (2) , 294-308
Abstract
In this study, the drying kinetics of cotton bobbin drying process in a pressurized hot-air convective bobbin dryer was investigated, and a drying model was introduced for the simulation of drying. Tests were conducted for drying temperatures of 70℃, 80℃, and 90℃; effective drying air pressures of 1, 2, and 3 bars; three volumetric flow rates of 42.5, 55, and 67.5 m3/h; and for three different bobbin diameters of 10, 14, and 18 cm. Optimum drying conditions were specified in terms of drying time and energy consumption. Results indicate that the total drying time depends significantly on the drying temperature, pressure, and volumetric flow rate. Results show that the minimum energy consumption is obtained for low values of drying air temperatures and pressures, and for moderate and high values of drying air volumetric flow rates. It was also found that the Page model is suitable for simulating the drying behavior of cotton yarn bobbins. Finally, results show that effective diffusion coefficient values are between 1.132 × 10−7 m2/s and 3.453×10−7 m2/s depending on the values of drying parameters.Keywords
This publication has 12 references indexed in Scilit:
- Determination of optimum operating conditions and simulation of drying in a textile drying processThe Journal of the Textile Institute, 2013
- Thermophysical parameter estimation of a wool bobbin during convective drying processInverse Problems in Science and Engineering, 2010
- A new termination control method for a clothes drying process in a clothes dryerApplied Energy, 2008
- Fabric-drying process in domestic dryersApplied Energy, 2008
- Mathematical Modelling of Drying of Rough Rice in StacksFood Science and Technology International, 2007
- Exergetic performance assessment of a stenter system in a textile finishing millInternational Journal of Energy Research, 2007
- A model of through-air drying of tufted textile materialsInternational Journal of Heat and Mass Transfer, 2002
- Vacuum assisted drying of hydrophilic plates: static drying experimentsInternational Journal of Heat and Mass Transfer, 1998
- Evaluation of Textile Bobbins Drying Processes: Experimental and Modelling StudiesDrying Technology, 1995
- Effects of drying conditions on properties of textile yarnsJournal of Research of the National Bureau of Standards, 1940