InAlAs/InGaAs Metamorphic High Electron Mobility Transistor with Cu/Pt/Ti Gate and Cu Airbridges
Authors:
- 1 May 2007
- journal article
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 46 (5R) , 2848
Abstract
The use of a Cu/Pt/Ti Schottky contact structure and Cu-based airbridges for high-frequency metamorphic high electron mobility transistor (MHEMT) is successfully developed. The material characteristics of the Cu/Pt/Ti Schottky contact on i-InAlAs were studied. Judging from the results of the X-ray diffraction analysis, Auger electron spectroscopy, and transmission electron microscopy, the Cu/Pt/Ti Schottky contact structure on InAlAs was very stable after annealing at 350 °C. However, after 400 °C annealing, the reaction of copper with the layers underneath started to occur and formed the Cu4Ti phase. The Cu-metallized MHEMT using the proposed Cu/Pt/Ti T-gate structure and Cu-based airbridges has a saturated drain current of 673 mA/mm and a maximum transconductance of 750 mS/mm. The gate to drain breakdown voltage measured was 14.5 V at a gate reverse current of -1 mA/mm. The device also demonstrated a cutoff frequency Ft of 90 GHz and a maximum frequency of oscillation Fmax of 165 GHz. An MHEMT with a Au/Pt/Ti gate was fabricated and compared with an MHEMT fabricated with the proposed Cu/Pt/Ti gate. These two kinds of MHEMTs showed similar Ft and Fmax. These results demonstrate that the Cu/Pt/Ti T-gate and Cu-based airbridges can be used for MHEMT fabrication with excellent electrical characteristics.Keywords
This publication has 10 references indexed in Scilit:
- Thermal stability of Ti∕Pt∕Cu Schottky contact on InAlAs layerApplied Physics Letters, 2006
- Copper-Airbridged Low-Noise GaAs PHEMT With$hboxTi/hboxWN_x/hboxTi$Diffusion Barrier for High-Frequency ApplicationsIEEE Transactions on Electron Devices, 2006
- Low-Noise Metamorphic HEMTs With Reflowed 0.1-$muhbox m$T-GateIEEE Electron Device Letters, 2004
- Metamorphic In/sub 0.4/Al/sub 0.6/As/In/sub 0.4/Ga/sub 0.6/As HEMTs on GaAs substrateIEEE Electron Device Letters, 1999
- InAlAs/InGaAs metamorphic HEMT with high current density and high breakdown voltageIEEE Electron Device Letters, 1998
- Effect on thermal stability of a Cu/Ta/Si heterostructure of the incorporation of cerium oxide into the Ta barrierJournal of Applied Physics, 1998
- Metamorphic InAlAs/InGaAs HEMTs on GaAs substrates with a novel composite channels designIEEE Electron Device Letters, 1996
- Tantalum as a diffusion barrier between copper and silicon: Failure mechanism and effect of nitrogen additionsJournal of Applied Physics, 1992
- Tantalum as a diffusion barrier between copper and siliconApplied Physics Letters, 1990
- Mechanism of Diffusion of Copper in GermaniumPhysical Review B, 1956