A comparative quality assessment of textile composite using NDT and geometrical inspection techniques
Authors:
- 13 January 2014
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 35 (9) , 1818-1825
Abstract
One of the major challenges in textile composites is the verification of their manufacturing quality, which has large influence on the mechanical properties. Quality assessment of these composites needs to have sufficient knowledge about the various types of nondestructive techniques and their inspection. The aim of this article is to evaluate the potential of three inspection techniques named ultrasounds, vibrations, dimensional measurement for detecting textile reinforcement defects in composites. The research work was focused on two types of defects, namely fiber/yarn breakage and ply misorientation, applied to woven textiles composite produced by vacuum assistant resin transfer molding. Fabric misorientation appeared to have an influence on the dynamic behavior of the textile composite samples. Potential solutions have also been identified to solve the issue of signal attenuation caused by the fabric observed during conventional and polar ultrasonic C‐scanning. A closer look at plates surface around eliminated unit cells by coordinate measuring machine at mesoscale did not appear any specific abnormality on due to artificially induced defect. POLYM. COMPOS., 35:1818–1825, 2014. © 2014 Society of Plastics EngineersKeywords
This publication has 18 references indexed in Scilit:
- Experimental characterization of high-speed impact damage behavior in a three-dimensionally woven SiC/SiC compositeComposites Part A: Applied Science and Manufacturing, 2010
- Effect of Fiber Content on Void Morphology in Resin Transfer Molded E-Glass/Epoxy CompositesJournal of Engineering Materials and Technology, 2009
- Modeling Flow in Compression Resin Transfer Molding for Manufacturing of Complex Lightweight High-Performance Automotive PartsJournal of Composite Materials, 2008
- Analysis of the vacuum infusion moulding process: I. Analytical formulationComposites Part A: Applied Science and Manufacturing, 2005
- Damage Detection of Composite Structures Using Dynamic AnalysisKey Engineering Materials, 2005
- Non-Linear Vibration of a Delaminated Composite BeamKey Engineering Materials, 2005
- Detection of Fiber Direction in Composites by Means of a High-Frequency Wide-Bounded Ultrasonic Beam and Schlieren PhotographyResearch in Nondestructive Evaluation, 2005
- Vibration damping for crack detection in composite laminatesComposites Part A: Applied Science and Manufacturing, 2004
- Ultrasonic nondestructive evaluation of cracked composite laminatesComposites Engineering, 1991
- The location of defects in structures from measurements of natural frequenciesThe Journal of Strain Analysis for Engineering Design, 1979