Investigation on the dynamic behavior of machine tool with respect to different worktable feed rates
Authors:
- 25 August 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 253-256
Abstract
With the rapid application of high speed machining, the feed rate of moving parts has an important influence on the dynamics of high speed machine tool. In this paper, a method of modal decoupling of Operational Deflection Shapes (ODS) was proposed to investigate the dynamic behavior of machine tool with respect to different worktable feed rates. Based on this method, the dominant frequencies vibration of the machine tool at different frequencies and its transformation at different worktable feed rates was identified. Finally, a series of empty running experiments were performed under different worktable feed rates. The experimental results show that (i) the change of worktable feed rate will affect the contribution of different modes vibration to the machine tool vibration; (ii) the contribution of a certain mode vibration to the machine tool vibration is different at different worktable feed rates; (iii) with the worktable feed rate increasing, the change rule of dominant frequency vibration participation is from multimode participation to single mode dominant, and then to the multimode participation. This research will provide valuable information for the selection of machine tool operation parameters and the optimization design of machine tool structure.Keywords
This publication has 12 references indexed in Scilit:
- A method to predict position-dependent structural natural frequencies of machine toolInternational Journal of Machine Tools and Manufacture, 2015
- A new approach to identifying the dynamic behavior of CNC machine tools with respect to different worktable feed speedsInternational Journal of Machine Tools and Manufacture, 2013
- Rapid evaluation and optimization of machine tools with position-dependent stabilityInternational Journal of Machine Tools and Manufacture, 2013
- Position-Dependent Multibody Dynamic Modeling of Machine Tools Based on Improved Reduced Order ModelsJournal of Manufacturing Science and Engineering, 2013
- Estimation of machine-tool dynamic parameters during machining operation through operational modal analysisInternational Journal of Machine Tools and Manufacture, 2009
- Investigations into the effect of cutting conditions on surface roughness in turning of free machining steel by ANN modelsJournal of Materials Processing Technology, 2008
- Chatter Stability of Metal Cutting and GrindingCIRP Annals, 2004
- Machining contour errors as ensembles of cutting, feeding and machine structure effectsInternational Journal of Machine Tools and Manufacture, 2003
- Study of Factors Affecting the Surface Quality in Ultra-Precision Diamond TurningMaterials and Manufacturing Processes, 2000
- Analytical Prediction of Stability Lobes in MillingCIRP Annals, 1995