The mean velocity profile of a smooth-flat-plate turbulent boundary layer at high Reynolds number
- 6 December 2010
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 665, 357-381
Abstract
Smooth flat-plate turbulent boundary layers (TBLs) have been studied for nearly a century. However, there is a relative dearth of measurements at Reynolds numbers typical of full-scale marine and aerospace transportation systems (Reθ = Ueθ/ν > 105, where Ue = free-stream speed, θ = TBL momentum thickness and ν = kinematic viscosity). This paper presents new experimental results for the TBL that forms on a smooth flat plate at nominal Reθ values of 0.5 × 105, 1.0 × 105 and 1.5 × 105. Nominal boundary layer thicknesses (δ) were 80–90mm, and Karman numbers (δ+) were 17000, 32000 and 47000, respectively. The experiments were conducted in the William B. Morgan Large Cavitation Channel on a polished (k+ < 0.2) flat-plate test model 12.9m long and 3.05m wide at water flow speeds up to 20ms−1. Direct measurements of static pressure and mean wall shear stress were obtained with pressure taps and floating-plate skin friction force balances. The TBL developed a mild favourable pressure gradient that led to a streamwise flow speed increase of ~2.5% over the 11m long test surface, and was consistent with test section sidewall and model surface boundary-layer growth. At each Reθ, mean streamwise velocity profile pairs, separated by 24cm, were measured more than 10m from the model's leading edge using conventional laser Doppler velocimetry. Between these profile pairs, a unique near-wall implementation of particle tracking velocimetry was used to measure the near-wall velocity profile. The composite profile measurements span the wall-normal coordinate range from y+ < 1 to y > 2δ. To within experimental uncertainty, the measured mean velocity profiles can be fit using traditional zero-pressure-gradient (ZPG) TBL asymptotics with some modifications for the mild favourable pressure gradient. The fitted profile pairs satisfy the von-Kármán momentum integral equation to within 1%. However, the profiles reported here show distinct differences from equivalent ZPG profiles. The near-wall indicator function has more prominent extrema, the log-law constants differ slightly, and the profiles' wake component is less pronounced.Keywords
This publication has 35 references indexed in Scilit:
- An experimental investigation of a highly accelerated turbulent boundary layerJournal of Fluid Mechanics, 2009
- Bubble-induced skin-friction drag reduction and the abrupt transition to air-layer drag reductionJournal of Fluid Mechanics, 2008
- Properties of the mean momentum balance in turbulent boundary layer, pipe and channel flowsJournal of Fluid Mechanics, 2005
- Debate Concerning the Mean-Velocity Profile of a Turbulent Boundary LayerAIAA Journal, 2003
- Evaluation of the Barenblatt–Chorin–Prostokishin power law for turbulent boundary layersPhysics of Fluids, 2002
- Reynolds-number scaling of the flat-plate turbulent boundary layerJournal of Fluid Mechanics, 2000
- Turbulent Flows2000
- Near-wall measurements in a three-dimensional turbulent boundary layerJournal of Fluid Mechanics, 1997
- A high-resolution laser Doppler anemometer for three-dimensional turbulent boundary layersExperiments in Fluids, 1996
- Local isotropy in turbulent boundary layers at high Reynolds numberJournal of Fluid Mechanics, 1994