UVA and UVB light emitting diodes with Al y Ga 1− y N quantum dot active regions covering the 305–335 nm range
Authors:
- J BraultJ Brault
- M Al KhalfiouiMKM Al Khalfioui
- S MattaSMS Matta
- B DamilanoBDB Damilano
- M LerouxMLM Leroux
- S ChenotSCS Chenot
- M KorytovMKM Korytov
- J E NkeckJNJ E Nkeck
- P VennéguèsPVP Vennéguès
- J–Y DubozJDJ–Y Duboz
- J MassiesJMJ Massies
- B GilBGB Gil
- 4 June 2018
- journal article
- research article
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 33 (7) , 075007
Abstract
Ultra-violet (UV) light emitting diodes (LEDs) using III-N quantum dot (QD) active regions have been fabricated by molecular beam epitaxy on (0001)-oriented sapphire substrates. By using the epitaxial compressive stress between the QD material and the template/barrier layers, leading to a 2D–3D growth mode transition, self-assembled Al y Ga 1− y N QDs with a nominal Al composition of 10% and 20% have been fabricated on Al 0.6 Ga 0.4 N. Atomic force microscopy and transmission electron microscopy measurements show high QD densities, ranging between 2 × 10 11 –5 × 10 11 cm −2 , and height and diameter distributions between 1.5–3 nm and 5–20 nm. LED structures including two different Al y Ga 1− y N/Al 0.6 Ga 0.4 N (0001) QD active regions have then been fabricated and processed using a standard planar geometry and squared mesa structures. Current–voltage characteristics and electroluminescence (EL) measurements have been performed at room temperature. In particular, the EL properties are investigated in terms of spectral range and wavelength shift as a function of the injection current density. Typically, an emission between 325 and 335 nm is obtained for Al 0.1 Ga 0.9 N QDs and between 305 and 320 nm for Al 0.2 Ga 0.8 N QDs. The LED characteristics (EL wavelength and broadening) are then correlated to the QD structural properties and the results, supported by calculations, show the main influence of the QD height dispersion and composition fluctuations. Finally, the light output intensity variation as a function of the injection current density has also been investigated and is discussed in terms of injection and recombination mechanisms in the devices.Keywords
Funding Information
- Agence Nationale de la Recherche (GANEX (ANR-11-LABX-0014), ANR Project <ANR-14-CE26-0025-01)
This publication has 41 references indexed in Scilit:
- Mechanism of GaN quantum dot overgrowth by Al0.5Ga0.5N: Strain evolution and phase separationJournal of Applied Physics, 2012
- White light emitting diodes with super-high luminous efficacyJournal of Physics D: Applied Physics, 2010
- Fabrication of a low threading dislocation density ELO‐AlN template for application to deep‐UV LEDsphysica status solidi (c), 2009
- Deep ultraviolet emitting AlGaN quantum wells with high internal quantum efficiencyApplied Physics Letters, 2009
- Radiative lifetime of a single electron-hole pair inquantum dotsPhysical Review B, 2006
- Enhanced deep ultraviolet luminescence from AlGaN quantum wells grown in the three-dimensional modeApplied Physics Letters, 2005
- AlGaN Deep-Ultraviolet Light-Emitting DiodesJapanese Journal of Applied Physics, 2005
- A UV Light-Emitting Diode Incorporating GaN Quantum DotsJapanese Journal of Applied Physics, 2003
- From Relaxed to Highly Tensily Strained GaN Grown on 6H-SiC and Si(111): Optical CharacterizationMaterials Science Forum, 2001
- Stranski-Krastanov growth mode during the molecular beam epitaxy of highly strained GaNPhysical Review B, 1997