Estimation of stress distribution and risk of failure for maxillary premolar restored by occlusal veneer with different CAD/CAM materials and preparation designs
- 7 February 2020
- journal article
- research article
- Published by Springer Nature in Clinical Oral Investigations
- Vol. 24 (9) , 3157-3167
Abstract
Objectives To compare stress distribution and failure probability in maxillary premolars restored by simple occlusal veneer (SOV) and buccal-occlusal veneer (BOV) with 3 different CAD/CAM materials. Materials and methods A maxillary premolar was digitized by a micro-CT scanner. Three-dimensional dynamic scan data were transformed, and finite element models of 2 different models (SOV and BOV restored teeth) were designed. Three different CAD/CAM materials, including lithium disilicate glass ceramic (LD) IPS e.max CAD, polymer-infiltrated ceramic-network (PICN) Vita Enamic, and resin nano-ceramic (RNC) Lava Ultimate, were designated to both veneers. Maximum principle stresses were determined by applying a 300-N axial load to the occlusal surface. Weibull analyses were performed to calculate the failure probability of the models. Results LD-restored teeth showed the highest stress in the veneer, lowest stress in substrate teeth, and lowest failure probability for the overall system; RNC-restored teeth showed the lowest stress in the veneer, highest stress in substrate teeth, and highest failure probability. No significant differences were found in the cement layer among the different models. No significant differences of stress and failure probability existed between SOV and BOV preparations. Conclusions CAD/CAM composite resin occlusal veneers bear lower maximum stress than ceramic veneers. Teeth restored by composite veneers are more prone to failure than those restored by ceramic veneers. Additional reduction of the buccal surface did not increase the stress on the occlusal veneer under axial load. Clinical relevance Both occlusal veneers could be used under physiological masticatory force. CAD/CAM glass ceramic was safer than composite resins.Keywords
Funding Information
- Sun Yat-sen University (2016006)
This publication has 36 references indexed in Scilit:
- The effect of internal roughness and bonding on the fracture resistance and structural reliability of lithium disilicate ceramicDental Materials, 2017
- Influence of remaining tooth structure and restorative material type on stress distribution in endodontically treated maxillary premolars: A finite element analysisThe Journal of Prosthetic Dentistry, 2017
- Chairside CAD/CAM materials. Part 2: Flexural strength testingDental Materials, 2017
- Chairside CAD/CAM materials. Part 1: Measurement of elastic constants and microstructural characterizationDental Materials, 2017
- Dental biomaterials for chairside CAD/CAM: State of the artThe Journal of Advanced Prosthodontics, 2017
- Influence of restoration thickness and dental bonding surface on the fracture resistance of full-coverage occlusal veneers made from lithium disilicate ceramicDental Materials, 2015
- Effect of elasticity on stress distribution in CAD/CAM dental crowns: Glass ceramic vs. polymer–matrix compositeJournal of Dentistry, 2015
- Clinical outcomes of lithium disilicate single crowns and partial fixed dental prostheses: A systematic reviewThe Journal of Prosthetic Dentistry, 2014
- Novel-design ultra-thin CAD/CAM composite resin and ceramic occlusal veneers for the treatment of severe dental erosionThe Journal of Prosthetic Dentistry, 2011
- A prospective 15-year evaluation of extensive dentin–enamel-bonded pressed ceramic coveragesDental Materials, 2010