Design and analysis of liquid cooling plates for different flow channel configurations
Open Access
- 1 January 2022
- journal article
- research article
- Published by National Library of Serbia in Thermal Science
- Vol. 26 (2 Part B) , 1463-1475
Abstract
A number of thermal management devices are used to actuate concentrated electronic appliances in an efficient way. A liquid cooling plate acts as a heat sink enclosed by materialized walls. This work aims to carry out design of liquid cooling plates such that the heat diffused by the electronic equipment is removed while their temperatures levels remain within safe limits. The liquid cooling plates expose ?cold surfaces? to electronic appliances. The performance of a cooling plate is estimated depending upon heat carrying capacity, associated heat transfer rates and concentrated thermal regions on the plate surface. For this study, the design of liquid cooling plate was done with SOLIDWORKS. Pure water was used as a working fluid in test channels. A comparative analysis of flow distribution, temperature contours, pressure drop, and pumping power for different channel configurations was carried out with ANSYS. It was observed that a channel configuration is of key importance in liquid cooling plates. The findings from this study are beneficial for the optimum design of cooling systems for high heat flux applications, i.e., in electronic devices, computer processors and automotive engines.Keywords
This publication has 36 references indexed in Scilit:
- Single-Phase and Two-Phase Hybrid Cooling Schemes for High-Heat-Flux Thermal Management of Defense ElectronicsJournal of Electronic Packaging, 2009
- Thermal Optimization of a Microchannel Heat Sink With Trapezoidal Cross SectionJournal of Electronic Packaging, 2009
- Measurement of flow maldistribution in parallel channels and its application to ex-situ and in-situ experiments in PEMFC water management studiesInternational Journal of Heat and Mass Transfer, 2009
- Numerical study of pin-fin heat sink with un-uniform fin height designInternational Journal of Heat and Mass Transfer, 2008
- A numerical model for heat sinks with phase change materials and thermal conductivity enhancersInternational Journal of Heat and Mass Transfer, 2006
- An experimental and numerical investigation of flow patterns in the entrance of plate-fin heat exchangerInternational Journal of Heat and Mass Transfer, 2006
- Experiments and modeling of the hydraulic resistance and heat transfer of in-line square pin fin heat sinks with top by-pass flowInternational Journal of Heat and Mass Transfer, 2005
- Three-dimensional thermal analysis of heat sinks with circular cooling micro-channelsInternational Journal of Heat and Mass Transfer, 2004
- Flow maldistribution in heat exchangersApplied Thermal Engineering, 1999
- Cooling of a Multichip Electronic Module by Means of Confined Two-Dimensional Jets of Dielectric LiquidJournal of Heat Transfer, 1990