A Method for Matching Two-Stage Turbocharger System and Its Influence on Engine Performance
- 21 February 2019
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 141 (5)
Abstract
Matching of a two-stage turbocharging system is important for high efficiency engines because the turbocharger is the most effective method of exhaust heat recovery. In this study, we propose a method to match a two-stage turbocharging system for high efficiency over the entire range of operational conditions. Air flow is an important parameter because it influences combustion efficiency and heat load performance. First, the thermodynamic parameters of the engine and the turbocharging system are calculated in eight steps for selecting and matching the turbochargers. Then, by designing the intercooler intensity, distribution of pressure ratio, and compressor operational efficiency, it is ensured that the turbochargers not only meet the air flow requirements but also operate with high efficiency. The concept of minimum total drive power of the compressors is introduced at a certain boost pressure. It is found that the distribution of pressure ratio of the high- and low-pressure (LP) turbocharger should be regulated according to the engine speed by varying the rack position of the variable geometry turbocharger (VGT) to obtain the minimum total drive work. It is verified that two-stage turbochargers have high efficiency over the entire range of operational conditions by experimental research. Compared with the original engine torque, low-speed torque is improved by more than 10%, and the engine low fuel consumption area is broadened.Keywords
Funding Information
- National Natural Science Foundation of China (51506144)
This publication has 16 references indexed in Scilit:
- Study of two-stage turbine characteristic and its influence on turbo-compound engine performanceEnergy Conversion and Management, 2015
- Emission Reduction Potential by Means of High Boost and Injection Pressure at Low- and Mid-Load for a Common Rail Diesel Engine under High EGR RatesSAE International Journal of Advances and Current Practices in Mobility, 2013
- Homogeneous Charge Compression Ignition (HCCI) combustion: Implementation and effects on pollutants in direct injection diesel enginesApplied Energy, 2011
- An experimental study of fuel injection strategies in CAI gasoline engineExperimental Thermal and Fluid Science, 2011
- Impact of two-stage turbocharging architectures on pumping losses of automotive engines based on an analytical modelEnergy Conversion and Management, 2010
- Potential of two-stage turbocharging on MAN Diesel’s 32 / 44 CRMTZ Worldwide, 2008
- Modeling and Control of Diesel Engines Equipped with a Two-Stage Turbo-SystemSAE International Journal of Advances and Current Practices in Mobility, 2008
- Diesel engine development in view of reduced emission standardsEnergy, 2008
- Experiments on the influence of inlet charge and coolant temperature on performance and emissions of a DI Diesel engineExperimental Thermal and Fluid Science, 2006
- An investigation into lowest acceptable combustion temperatures for hydrocarbon fuels in HCCI enginesProceedings of the Combustion Institute, 2005