High‐Temperature Extrusion Behavior of a Superplastic Zirconia‐Based Ceramic
Authors:
- 1 July 1990
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 73 (7) , 1922-1927
Abstract
Workability of 3‐mol%‐yttria‐stabilized tetragonal ZrO 2 has been gauged through a series of extrusion experiments performed under vacuum with graphite dies at 1500°C and 35 MPa piston stress. It is shown that dense and smooth extrusions can be obtained from solid billets when graphite paper is used as a lubricant. Sigmoidal dies and conical dies with cone angles of 18.4°, 26.6°, and 45° and diameter ratios of 1.5, 2, and 3 were used to explore extrusion behavior. Observed piston velocities correspond to what may be predicted from the experimental uniaxial constitutive creep equation and a simple slab analysis. A precise analysis, however, is not attempted because of lack of steady‐state behavior of the material itself.Keywords
This publication has 8 references indexed in Scilit:
- Superplastic properties of a fine-grained yttria-stabilized tetragonal polycrystal of zirconiaScripta Metallurgica, 1988
- Microstructural Change of Polycrystalline Ba-Ferrite (BaO⋅6Fe2O3) by Hot-Extrusion ProcessingJournal of the Ceramic Association, Japan, 1987
- Hot Forging Characteristics of Fine‐Grained ZrO 2 and Al 2 O 3 /ZrO 2 CeramicsJournal of the American Ceramic Society, 1986
- Superplasticity of Yttria-Stabilized Tetragonal ZrO2PolycrystalsAdvanced Ceramic Materials, 1986
- Compressive Deformation Properties and Microstructures in the Superplastic Y-TZPJournal of the Ceramic Association, Japan, 1986
- Direct extrusion of rate-sensitive materials through conical diesRevue de Physique Appliquée, 1977
- On the Extrusion in Superplastic ConditionsJournal of Engineering for Industry, 1975
- The extrusion force and the mean strain rate during the extrusion of strain rate sensitive materialsMetallurgical Transactions, 1970