Variable DC-Link Control Loop Design for an Integrated Two-Stage AC/DC Converter
Open Access
- 22 September 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 4 (1) , 99-107
Abstract
This paper presents an innovative technique of synthesizing variable DC-link voltage control loop for a two-stage integrated AC-DC converter, which is a cascaded combination of a single-phase CCM interleaved totem-pole power factor correction (PFC) and a half-bridge CLLC resonant converter. Although the variable DC-link control exhibits a better overall efficiency than the fixed DC-link control, it faces issues of (i) loss of output voltage regulation and (ii) low frequency oscillations in the DC voltages and inductor current. In order to address and analyze these issues, both time-domain and frequency-domain studies of the control loop are performed, which led to two different voltage loop controller configurations, resolving the oscillation and regulation issues. As verification to the proof-of-concept, a hardware prototype of an integrated AC-DC converter is developed and tested up to 2kW. The experimental results exhibit a power factor of 0.992, peak efficiency of > 94% and a total harmonic distortion (THD) of < 5%, with the elimination of low frequency oscillation of the DC voltage waveforms.Keywords
Funding Information
- National Science Foundation (1602012)
This publication has 21 references indexed in Scilit:
- Dynamic Strategy for Efficiency Estimation in a CCM-Operated Front-End PFC Converter for Electric Vehicle Onboard ChargerIEEE Transactions on Transportation Electrification, 2017
- An Integrated Control Strategy for a Fast Start-Up and Wide Range Input Frequency Operation of a Three-Phase Boost-Type PFC Converter for More Electric AircraftIEEE Transactions on Vehicular Technology, 2017
- An Electrolytic Capacitorless Bidirectional EV Charger for V2G and V2H ApplicationsIEEE Transactions on Power Electronics, 2016
- Variable-Switching-Frequency State-Feedback Control of a Phase-Shifted Full-Bridge DC/DC ConverterIEEE Transactions on Power Electronics, 2016
- Implementation of a 3.3-kW DC–DC Converter for EV On-Board Charger Employing the Series-Resonant Converter With Reduced-Frequency-Range ControlIEEE Transactions on Power Electronics, 2016
- A novel approach to design EV battery chargers using SEPIC PFC stage and optimal operating point tracking technique for LLC converter2014
- Design and Control for High Efficiency in High Step-Down Dual Active Bridge Converters Operating at High Switching FrequencyIEEE Transactions on Power Electronics, 2013
- A New Phase-Shifted Full-Bridge Converter With Maximum Duty Operation for Server Power SystemIEEE Transactions on Power Electronics, 2011
- Stability problems and input impedance improvement for cascaded power electronic systems2004
- A high-performance single-phase rectifier with input power factor correctionIEEE Transactions on Power Electronics, 1996