New Ultra-fast Real-time Active Load-pull Measurements for High Speed RF Power Amplifier Design
Authors:
- 1 June 2007
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 0149645X,p. 1493-1496
Abstract
To accelerate the speed of RF power amplifier design, a novel ultra-fast real-time active load-pull measurement based on a large signal network analyzer (LSNA) is presented. Real-time load-pull conventionally uses a single-tone excitation at the transistor's output to achieve a time varying load impedance. However this approach still requires multiple measurements at different power levels to map the Smith Chart and determine the optimal load termination. This paper proposes a modulated two-tone excitation method for mapping the Smith Chart in a single 10 ms LSNA measurement. Experiments for the lst and 2nd harmonic demonstrate that this ultra-fast real-time active load-pull permits to identify the optimal load impedance in one measurement.Keywords
This publication has 3 references indexed in Scilit:
- Harmonic Load-Pull2005
- A New Load-Pull Characterization Method for Microwave Power Transistors2005
- Measurement and control of current/voltage waveforms of microwave transistors using a harmonic load-pull system for the optimum design of high efficiency power amplifiersIEEE Transactions on Instrumentation and Measurement, 1999