Multi-Scale Modeling and Simulation of Thermoplastic Automated Tape Placement: Effects of Metallic Particles Reinforcement on Part Consolidation
Open Access
- 4 May 2019
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 9 (5) , 695
Abstract
This paper concerns engineered composites integrating metallic particles to enhance thermal and electrical properties. However, these properties are strongly dependent on the forming process itself that determines the particle distribution and orientation. At the same time, the resulting enhanced thermal properties affect the reinforced resin viscosity whose flow is involved in the intimate contact evolution. Thus, a subtle and intricate coupling appears, and the process cannot be defined by ignoring it. In this paper, we analyze the effects of particle concentration and orientation on the process and processability. For this purpose, three main models are combined: (i) a multi-scale surface representation and its evolution, by using an appropriate numerical model; (ii) flow-induced orientation, and (iii) the impact of the orientation state on the homogenized thermal conductivity.Keywords
This publication has 23 references indexed in Scilit:
- Tape surface characterization and classification in automated tape placement processability: Modeling and numerical analysisAIMS Materials Science, 2018
- Sensitivity thermal analysis in the laser-assisted tape placement processAIMS Materials Science, 2018
- On the properties evolution of engineered surfaces of thin reinforced thermoplastic tapes during consolidationSurface Topography: Metrology and Properties, 2017
- On the use of model order reduction for simulating automated fibre placement processesAdvanced Modeling and Simulation in Engineering Sciences, 2016
- High-resolution thermal analysis at thermoplastic pre-impregnated acomposite interfacesComposite Interfaces, 2015
- Identification of non uniform thermal contact resistance in automated tape placement processInternational Journal of Material Forming, 2013
- PGD-Based Computational Vademecum for Efficient Design, Optimization and ControlArchives of Computational Methods in Engineering, 2013
- First steps towards an advanced simulation of composites manufacturing by automated tape placementInternational Journal of Material Forming, 2012
- Advanced simulation of models defined in plate geometries: 3D solutions with 2D computational complexityComputer Methods in Applied Mechanics and Engineering, 2012
- A fractal Cantor set based description of interlaminar contact evolution during thermoplastic composites processingJournal of Materials Science, 2001