Mechanical Impedance of Tillage Pans in Atlantic Coastal Plains Soils and Relationships with Soil Physical, Chemical, and Mineralogical Properties
Authors:
- R. E. StittRSR. E. Stitt
- D. K. CasselDCD. K. Cassel
- S. B. WeedSWS. B. Weed
- 1 January 1982
- journal article
- research article
- Published by Wiley in Soil Science Society of America Journal
- Vol. 46 (1) , 100-106
Abstract
Mechanical impedance (MI) is an important property of root‐restricting, tillage‐induced pans common to Ultisols in the Coastal Plain of North Carolina. The relationship between MI and other soil properties is not well understood. The purposes of this study were to quantify selected physical, chemical, and mineralogical properties of tillage pans and to correlate MI to these measurements. Mechanical impedance of tillage‐induced pans at 50 sites in the Coastal Plain of North Carolina was measured with a constant rate cone penetrometer on triplicate, undisturbed soil cores. Sites were selected to give a broad range of measured MI values. Impedance at a soil water pressure (SWP) of ‐0.10 bar ranged from 3.8 to 39.4 kg/cm 2 ; for ‐1.00 bar, 19 to 98 kg/cm 2 . Other measured soil properties included particle size, the particle‐size coefficient of uniformity (CU), bulk density ( D b ), saturated hydraulic conductivity, dense soil angle of repose (DSAR), soil water characteristic, cation exchange capacity (CEC), external and total surface area, free iron oxides, and the amounts of organic matter, Ca, Mg, P, K, Mn, gibbsite, kaolinite, and amorphous silica and alumina. A stepwise regression procedure (maximum R ‐square improvement technique) was used to select the best models relating MI to the measured soil properties. For this grouping of soils, no one physical, chemical, or mineralogical parameter correlated well with MI. The best single variable model was found for P w as the independent variable but this relationship had an R 2 value of only 0.15. The best three‐variable model included P w , DSAR, and D b and had an R 2 = 0.67. When MI data was subjected to a log 10 transformation, the R 2 for the three‐variable model increased to 0.74.Keywords
This publication has 6 references indexed in Scilit:
- Effect of Particle Surface Roughness on Densification of Coarse‐Textured SoilSoil Science Society of America Journal, 1980
- THE EFFECT OF SAND CONTENT UPON CONE INDEX AND SELECTED PHYSICAL PROPERTIESSoil Science, 1980
- The Effect of Extractable Aluminum, Iron, and Silicon on Strength and Bonding of Fragipans of Northeastern OhioSoil Science Society of America Journal, 1979
- An Evaluation of Mechanical Impedance for Three Tillage Treatments on Norfolk Sandy LoamSoil Science Society of America Journal, 1978
- Particle Fractionation and Particle‐Size Analysis1965
- Laboratory Measurement of Hydraulic Conductivity of Saturated Soil1965