3D printing of TPMS structural ZnO ceramics with good mechanical properties
Authors:
- Jiaxiong LuJLJiaxiong Lu
- Peng DongPDPeng Dong
- Yongtao ZhaoYZYongtao Zhao
- Yan ZhaoYZYan Zhao
- Yong ZengYZYong Zeng
- 1 May 2021
- journal article
- research article
- Published by Elsevier in Ceramics International
- Vol. 47 (9) , 12897-12905
Abstract
No abstract availableKeywords
Funding Information
- Beijing Municipal Science and Technology Commission, Adminitrative Commission of Zhongguancun Science Park (KM202010005003)
- Kementerian Pendidikan Malaysia
- Ministry of Education of the People's Republic of China (6141A02033123)
This publication has 41 references indexed in Scilit:
- Additively manufactured metallic porous biomaterials based on minimal surfaces: A unique combination of topological, mechanical, and mass transport propertiesActa Biomaterialia, 2017
- Fabrication of ZnO periodic structures by 3D printingJournal of the European Ceramic Society, 2016
- Effective conductivities and elastic moduli of novel foams with triply periodic minimal surfacesMechanics of Materials, 2016
- Few layered graphene Sheet decorated by ZnO Nanoparticles for anti-bacterial applicationSuperlattices and Microstructures, 2015
- Preparation of semiconductor ZnO powders by sol–gel method: Humidity sensorsSensors and Actuators A: Physical, 2013
- Improvement of adsorptive desulfurization performance of Ni/ZnO adsorbent by doping with Mn additiveChinese Journal of Catalysis, 2013
- Photoinitiated Polymerization: Advances, Challenges, and OpportunitiesMacromolecules, 2010
- Preparation, characterization and activity evaluation of p–n junction photocatalyst p-ZnO/n-TiO2Applied Surface Science, 2008
- Fluid permeabilities of triply periodic minimal surfacesPhysical Review E, 2005
- Effect of the addition of ZnO seeds on the electrical proprieties of ZnO-based varistorsMaterials Chemistry and Physics, 2003