Tool Wear and Milling Characteristics for Hybrid Additive Manufacturing Combining Laser Powder Bed Fusion and In Situ High-Speed Milling
Open Access
Abstract
We report on milling and tool wear characteristics of hybrid additive manufacturing comprising laser powder bed fusion and in situ high-speed milling, a particular process in which the cutter mills inside the powder bed without any cooling lubricant being applicable. Flank wear is found to be the dominant wear characteristic with its temporal evolution over utilization period revealing the typical s-shaped dependence. The flank wear land width is measured by microscopy and correlated to the achievable surface roughness of milled 3D-printed parts, showing that for flank wear levels up to 100 m a superior surface roughness below 3 m is accessible for hybrid additive manufacturing. Further, based on this correlation recommended tool, life scenarios can be deduced. In addition, by optimizing the finishing tool start position and the number of afore-built layers, the milling process is improved with respect to the maximum millable angle for undercut surfaces of 3D-printed parts to 30° for the roughing process and to 40° for the entire machining process including finishing.
Keywords
This publication has 63 references indexed in Scilit:
- Comparison of the machinabilities of Ti6Al4V and TIMETAL® 54M using uncoated WC–Co toolsJournal of Materials Processing Technology, 2010
- Investigation into minimal-cutting-fluid application in high-speed milling of hardened steel using carbide millsInternational Journal of Machine Tools and Manufacture, 2009
- Growth of tool wear in turning of Ti-6Al-4V alloy under cryogenic coolingWear, 2007
- Residual stresses in selective laser sintering and selective laser meltingRapid Prototyping Journal, 2006
- Experimental and numerical investigation of the effect of spray cutting fluids in high speed millingJournal of Materials Processing Technology, 2006
- Experimental investigation to study the effect of solid lubricants on cutting forces and surface quality in end millingInternational Journal of Machine Tools and Manufacture, 2006
- Wear-mode mapping for the micro-scale abrasion testWear, 2003
- Wear mechanisms of cutting tools in high-speed cutting processesWear, 2001
- Effect of surface roughness of the titanium alloy Ti–6Al–4V on human bone marrow cell response and on protein adsorptionBiomaterials, 2001
- Increasing of cutting performance of PVD coated cemented carbide inserts in chipboard milling through improvement of the film adhesion, considering the coating cutting loadsSurface and Coatings Technology, 2000