Comparison of Measured and Theoretical Inter-Ring Gas Pressure on a Diesel Engine
Author:
- 1 October 1996
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Inter-ring gas pressure and piston ring motion are considered important for the control of oil consumption, particulate emissions, and reduced friction. For this reason, inter-ring gas pressure was measured on a diesel engine. Two different ring pack configurations were tested (positive and negative twist second rings). A significant difference in measured inter-ring pressure was observed. The measurements were compared to the predictions of a cylinder kit model with favorable results. Predictions showed that the observed difference between measured inter-ring pressures is caused by a significant difference in ring motion. The reasons for these differences are explained in this paper.Keywords
This publication has 6 references indexed in Scilit:
- An Integrated Model of Ring Pack PerformanceJournal of Engineering for Gas Turbines and Power, 1991
- Calculation of Flow in the Piston-Cylinder-Ring Crevices of a Homogeneous-Charge Engine and Comparison with ExperimentSAE International Journal of Advances and Current Practices in Mobility, 1989
- Tribology on reciprocating internal combustion engines.JSME International Journal, 1987
- Flow in the Piston-Cylinder-Ring Crevices of a Spark-Ignition Engine: Effect on Hydrocarbon Emissions, Efficiency and PowerSAE International Journal of Advances and Current Practices in Mobility, 1982
- Piston Ring Motion and Its Influence on Engine TribologySAE International Journal of Advances and Current Practices in Mobility, 1979
- Piston Ring Lubrication and Cylinder Bore Wear Analysis, Part I—TheoryJournal of Lubrication Technology, 1974