The Characterization and Passivation of Fixed Oxide Charges and Interface States in the $\hbox{Al}_{2}\hbox{O}_{3}/ \hbox{InGaAs}$ MOS System
- 18 September 2013
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 13 (4) , 429-443
Abstract
In this paper, we present a review of experimental results examining charged defect components in the Al2O3/In0.53Ga0.47As metal-oxide-semiconductor (MOS) system. For the analysis of fixed oxide charge and interface state density, an approach is described where the flatband voltage for n- and p-type Al2O3/In0.53Ga0.47As MOS structures is used to separate and quantify the contributions of fixed oxide charge and interface state density. Based on an Al2O3 thickness series (10-20 nm) for the n- and p-type In0.53Ga0.47As layers, the analysis reveals a positive fixed charge density ( ~ 9 ×1018 cm-3) distributed throughout the Al2O3 and a negative sheet charge density (- 8 × 1012 cm-2) located near the Al2O3/In0.53Ga0.47As interface. The interface state density integrated across the energy gap is ~1 ×1013 cm-2 and is a donor-type (+/0) defect. The density of the fixed oxide charge components is significantly reduced by forming gas (5 % H2/ 95% N2 ambient at 350 °C for 30 minutes) annealing. The interface state distribution obtained from multi-frequency capacitance-voltage and conductance-voltage measurements on either MOS structures or MOSFETs indicates a peak density located around the In0.53Ga0.47As midgap energy, with a sharp increase in the interface state density toward the valance band and evidence of interface states aligned with the In0.53Ga0.47As conduction band. The integrated interface state density obtained from multi-frequency capacitance-voltage and conductance-voltage analysis is in good agreement with the approach of comparing the flatband voltages in n- and p -type Al2O3/In0.53Ga0.47As MOS structures. Finally, this paper reviews recent work based on an optimization of the In0.53Ga0.47As surface preparation using (NH4)2S, combined with minimizing the transfer time to the atomic layer deposition reactor for Al2O3, which indicates interface state reduction and genuine surface inversion for both n- and p -type Al2O3/In0.53Ga0.47As MOS structures.Keywords
This publication has 67 references indexed in Scilit:
- Electrically active interface defects in the In0.53Ga0.47As MOS systemMicroelectronic Engineering, 2013
- Interface-State Modeling of $\hbox{Al}_{2}\hbox{O}_{3}$ –InGaAs MOS From Depletion to InversionIEEE Transactions on Electron Devices, 2012
- Interfacial chemistry of oxides on InxGa(1−x)As and implications for MOSFET applicationsCurrent Opinion in Solid State and Materials Science, 2011
- Identification of defect levels at InxGa1−xAs/oxide interfaces through hybrid functionalsMicroelectronic Engineering, 2011
- In-situ characterization of Ga2O passivation of In0.53Ga0.47As prior to high-k dielectric atomic layer depositionApplied Physics Letters, 2011
- Optimisation of the ammonium sulphide (NH4)2S passivation process on In0.53Ga0.47AsApplied Surface Science, 2011
- Small-Signal Response of Inversion Layers in High-Mobility $\hbox{In}_{0.53}\hbox{Ga}_{0.47}\hbox{As}$ MOSFETs Made With Thin High- $\kappa$ DielectricsIEEE Transactions on Electron Devices, 2010
- Atomically abrupt and unpinned Al2O3/In0.53Ga0.47As interfaces: Experiment and simulationJournal of Applied Physics, 2009
- On the interface state density at In0.53Ga0.47As/oxide interfacesApplied Physics Letters, 2009
- Nearly ideal electronic properties of sulfide coated GaAs surfacesApplied Physics Letters, 1987