Iron-based reversible adhesives: Effect of particles size on mechanical properties
Authors:
Open Access
- 17 October 2017
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 232 (8) , 1446-1455
Abstract
A hot melt adhesive – mainly used for bonding plastic component in automotive field – was modified with different iron-based particles to give it a reversible behaviour. Mechanical and physical properties of these reversible adhesives were experimentally assessed in the work. The modified adhesives, coupled with electromagnetic induction, are able to guarantee separation of the joints without any damage to the substrates for recycling, reuse or repairing of components. Single lap joint specimens were prepared using epoxy/glass fibres substrates and tests were carried out on neat and modified adhesive with 5% weight of iron and iron oxide. Three different Fe particles size were tested: 450 µm, 60 µm and 1–6 µm. The particles size of iron oxide was 50 nm. Separation was studied using single lap joint specimens under electro-magnetic induction. Experimental results showed that the maximum peak load decreases when the average particles sizes increase. The peak loads of the smallest particles were equal to the ones of the pristine adhesive. The elongation of the adhesives increases when the adhesive is modified with both iron and iron oxide particles. Finally, experimental tests on single lap joints coupled with electro-magnetic induction showed that separation of the substrates is possible using iron oxide particles. Electro-magnetic tests conducted on particles alone, helped to understand that bigger particles are able to overcome the melting temperature of the adhesive but hot-melt adhesives modified with these particles are not able to reach the melting. These tests showed that the number of particles into the adhesive matrix is very important for this kind of tests.Keywords
This publication has 18 references indexed in Scilit:
- Thermoplastic Adhesive for Automotive Applications2016
- Debonding on command of adhesive joints for the automotive industryInternational Journal of Adhesion and Adhesives, 2015
- Adhesive joining technologies activated by electro-magnetic external trimsInternational Journal of Adhesion and Adhesives, 2013
- Electrolytically assisted debonding of adhesives: An experimental investigationInternational Journal of Adhesion and Adhesives, 2012
- Materials, design and manufacturing for lightweight vehicles2010
- Adhesively bonded joints in composite materials: An overviewProceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, 2009
- Stress flow in thin-walled box beams obtained by adhesive bonding joining technologyInternational Journal of Adhesion and Adhesives, 2004
- Handbook of Adhesive Technology, Revised and Expanded2003
- ElectRelease – electrically disbonding epoxy adhesiveAssembly Automation, 2002
- Comparative studies on stresses in weld-bonded, spot-welded and adhesive-bonded jointsJournal of Materials Processing Technology, 1999