Research on the Microstructure and Mechanical Properties of WC-TiC-Co/steel Joints
Open Access
- 1 June 2021
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1948 (1) , 012115
Abstract
Wear-resistant layer of cemented carbide on steel can improve its wear properties in particular areas, such as oil drilling. Herein, the WC-TiC-Co/steel joint, the WC-TiC-Co wear-resistant layer covers the steel surface, is fabricated by infiltration brazed, using Cu-Zn filler alloy and WC particles as solder. The microstructure and mechanical properties of as-obtained joint are investigated. The Longitudinal interface has good bonding and the existence of transverse gaps are surveyed on interface between WC-TiC-Co and solder. The element Mapping test shows the distribution of Co element in WC-TiC-Co block is uneven. And the present of element interdiffusion forms the diffusion layer in the joining zone between base materials and solder. The hardness and phase tests indicate that Co3Fe7, W2C phase were produced during brazing, but there are few impacted on the hardness by Co3Fe7, W2C phase.Keywords
This publication has 3 references indexed in Scilit:
- Microstructure and mechanical properties of YG8/IN718 alloy joints prepared by vacuum brazingVacuum, 2019
- Failure analysis of tungsten carbide bearing on screw drillEngineering Failure Analysis, 2018
- A study on microstructure in the brazing interface of WC–TiC–Co hard alloysInternational Journal of Refractory Metals and Hard Materials, 2002