Comparative Analysis of Electrochemical Noise Generated During Stress Corrosion Cracking of AISI 304 Stainless Steel
Authors:
- M. LebanMLM. Leban
- 1 September 2000
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 56 (9) , 921-927
Abstract
Electrochemical noise measurements were performed on electrodes made from a sample of AISI 304 (UNS S30400) stainless steel. Potential and current noise were measured under open-circuit conditions in a three-electrode system, one of the electrodes being maintained under load and acting as a working electrode. Two types of electrode set-ups were used, which differed according to the method of load application. In the first case, the common electrode was a U-bend test specimen, which was subjected to a static, large, but undefined load. In the second case, it was a tensile test specimen, which was subjected to a gradually increasing load (the slow rate load test [SRLT]). U-bend tests were performed in a concentrated solution of magnesium chloride (MgCl2) at an elevated temperature, test specimens being dismantled and examined daily through a microscope. SRLT were conducted in a dilute solution of sodium thiocyanate (NaSCN) at room temperature, with simultaneous electrochemical noise (ECN) and load/elongation measurements. Toward the end of both types of tests, significant simultaneous spikes of voltage and current noise were observed. The spikes detected during SRLT correlated with drops in the applied load and sudden increases in elongation. After the tests were completed, several characteristic ECN time series, referring to both types of test specimen, were subjected to spectral and chaos analysis. Attempts to distinguish between the active cracking and nonactive cracking periods on the basis of the aforementioned types of analysis were unsuccessful since, in the case of the U-bend tests, the events that are typical for stress corrosion cracking (SCC) processes were too rare. In the case of the SRLT, the ECN time series were not stationary, which is a necessary condition for a successful outcome of such analyses.Keywords
This publication has 18 references indexed in Scilit:
- Comprehensive Dissolution Current Noise Analysis during Stress Corrosion Cracking of Cu3Au AlloysJournal of the Electrochemical Society, 1999
- Chaotic Analysis of Electrochemical Noise Measured on Stainless SteelJournal of the Electrochemical Society, 1995
- A review of electrochemistry of relevance to environment-assisted cracking in light water reactorsCorrosion Science, 1992
- Chaos during the Growth of an Artificial PitJournal of the Electrochemical Society, 1992
- Electrochemical noise measurements of stress corrosion cracking of sensitised austenitic stainless steel in high-purity oxygenated water at 288°CCorrosion Science, 1992
- The mechanism of intergranular stress corrosion cracking of sensitised austenitic stainless steel in dilute thiosulphate solutionCorrosion Science, 1992
- Shil'nikov chaos during copper electrodissolutionThe Journal of Physical Chemistry, 1988
- Determining Lyapunov exponents from a time seriesPhysica D: Nonlinear Phenomena, 1985
- Measuring the strangeness of strange attractorsPhysica D: Nonlinear Phenomena, 1983
- The measurement of corrosion using electrochemical noiseCorrosion Science, 1982