Mechanical and Durability Properties of Mortars Incorporating Red Mud, Ground Granulated Blast Furnace Slag, and Electric Arc Furnace Dust
Open Access
- 30 April 2021
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 11 (9) , 4110
Abstract
This research studies the properties of mortars incorporating waste materials including red mud (RM), ground granulated blast furnace slag (GGBFS), and electric arc furnace dust (EAFD). Ordinary Portland cement (OPC) was partially replaced with equal contents of RM, GGBFS, and EAFD at different ratios by weight (0, 5, 10, 15, 20, 30, 40, and 50%). Slump, compressive strength, splitting tensile strength, electrical resistivity, water absorption, resistance to freeze–thaw cycles, and durability under sodium sulphate and sulphuric acid attacks were investigated. Moreover, the microstructure of mortars cured in tap water and exposed to sulphuric acid was examined using scanning electron microscopy (SEM) and energy dispersive X-ray spectrometer (EDX). Cement replacement up to 20% led to a slight increase in compressive strength at 7, 28, and 120 days, while the results of durability tests showed that only up to 10% cement substitution could improve the durability of the mortar. A microstructural analysis showed that small waste grain portions in the matrix improved the whole mix density and the interfacial transition zone (ITZ) between aggregates and paste. The results of this study showed that there is an optimum replacement ratio of about 10%, beyond which the incorporation of these waste powders can cause degradation of concrete properties.Keywords
This publication has 78 references indexed in Scilit:
- Mechanical properties of GGBFS-based geopolymer concrete incorporating natural zeolite and silica fume with an optimum design using response surface methodJournal of Building Engineering, 2021
- Life cycle assessment of eco-friendly concrete mixtures incorporating natural zeolite in sulfate-aggressive environmentConstruction and Building Materials, 2021
- Towards Ultrahigh Performance Concrete Produced with Aluminum Oxide Nanofibers and Reduced Quantities of Silica FumeNanomaterials, 2020
- RETRACTED: Mechanical and durability properties of steel fibre-reinforced rubberised concreteConstruction and Building Materials, 2020
- Alkali-Activated Slag Paste with Different Mixing Water: A Comparison Study of Early-Age Paste Using Electrical ResistivityMaterials, 2020
- Performance of Concrete with Waste Granite Powder: The Effect of SuperplasticizersApplied Sciences, 2018
- Structural behavior of RC beams containing EAF slag as recycled aggregate: Numerical versus experimental resultsConstruction and Building Materials, 2018
- The greenhouse gas implications of using ground granulated blast furnace slag as a cement substituteJournal of Cleaner Production, 2015
- Carbon dioxide emissions and climate change: policy implications for the cement industryEnvironmental Science & Policy, 2005
- Strength development of ternary blended cement with limestone filler and blast-furnace slagCement and Concrete Composites, 2003