Tribological Characteristics of Yttria Stabilized Zirconia Nanolubricants
Author:
- 13 October 2014
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Nanolubricants are suspensions of nanoparticles in base fluids, a new challenge for thermal sciences provided by nanotechnology. The objective of this work is to analyze the thermal and tribological properties of yttria stabilized zirconia (YSZ) nanolubricants. Nanosized YSZ particles were prepared by milling YSZ (10μm) in a planetary ball mill equipped with vials using tungsten carbide balls. After 40 hrs, milled YSZ nanoparticles of sizes ranging from 70-90nm were obtained.The nanoparticles were characterized by Energy Dispersive X-ray analysis (EDXA), Scanning Electron microscope (SEM), Transmission Electron Microscope, Thermo Gravimetric-Differential Scanning Calorimeter and non contact 3D surface profilometer and the images of the same were obtained. The heat transfer properties of automotive engine lubricants were determined by utilization of measured thermal conductivity, viscosity index, density, flash point, fire point and pour point, which revealed that lubricants with additive constituents have a significant effect on the resultant heat transfer characteristics of the lubricants. The YSZ nanoparticles incorporated lubricants were evaluated for their potentials as effective solid lubricants at room temperature by using ball-on-disk tribometer.The lubricant without nanoparticles has a co-efficient of friction of 0.08-0.1 and a wear rate in the order of 10-4 mm3/Nm, while the lubricant with yttria stabilized zirconia nanoparticles exhibits a steady state co-efficient of friction of less than 0.07 and a wear rate in the order of 10−6 mm3/Nm at room temperature. Scratches and furrows are considered as the dominating wear mechanism of the disc applied with lubricants. However, for the disc applied with YSZ nanolubricants, the formation and effective spreading of the YSZ lubricating films are the most important factor to reduce the friction and wear rate.Keywords
This publication has 12 references indexed in Scilit:
- CuO, ZrO2 and ZnO nanoparticles as antiwear additive in oil lubricantsWear, 2008
- Phase stabilization in the Fe1−xMnxSi2 system induced by ball millingIntermetallics, 2007
- Radial mixing of particles in a dry batch ball millPowder Technology, 2006
- Synthesis and characterization of high-energy ball milled nanostructured Fe50Ni50Catalysis Today, 2006
- Wear properties of two-phase Al2O3/ZrO2 (Y2O3) ceramics at temperatures from 296 to 1073KTribology International, 2005
- Discrete element simulation of the dynamics of high energy planetary ball milling processesMaterials Science and Engineering: A, 2004
- Friction behaviour of solid oxide lubricants as second phase in α-Al2O3 and stabilised ZrO2 compositesWear, 2004
- Tribological properties of nanoscale alumina–zirconia compositesWear, 1999
- Effects of a second phase on the tribological properties of Al2O3 and ZrO2 ceramicsWear, 1997
- Microstructure and tribological properties of ZrO2 ceramicsWear, 1994