On the correctness of using two-dimensional representations in the analysis of cylindrical peg–hole insertion and withdrawal
Open Access
- 30 August 2023
- journal article
- research article
- Published by The Royal Society in Royal Society Open Science
- Vol. 10 (8) , 221021
Abstract
The cylindrical peg–hole system is a popular model in the study of assembly and disassembly operations. The analysis of peg–hole systems is customarily performed using simplified two-dimensional representations, viz . a vertical sectional view. However, evidence that this simplification accurately represents the system is lacking. This paper investigates the correctness of using two-dimensional instead of three-dimensional models for peg–hole system analysis, studying their geometrical and kinematic equivalence. Geometrical equivalence implies the contact points between the peg and hole are on a vertical sectional view plane. Kinematic equivalence requires that the forces and torques acting on the peg lie in the same sectional plane. The analysis indicates that while geometrical equivalence can be proven, kinematic equivalence is in general not verified. The severity of the error introduced by the two-dimensional simplification depends on the geometrical configuration and kinematic parameters of the peg–hole system. The effects of kinematic non-equivalence on the boundary conditions of jamming and wedging are discussed. The results of the analysis show that a two-dimensional peg–hole model may give wrong predictions on jamming. Also, the extra lateral error of the three-dimensional model reduces the boundary condition and the possibility of peg–hole wedging.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/N018524/1, EP/W00206X/1)
This publication has 20 references indexed in Scilit:
- In what way is remanufacturing good for the environment?2012
- Analyses of peg‐hole jamming in automatic assembly machinesAssembly Automation, 2011
- Dynamic analysis of vibratory insertion processAssembly Automation, 2011
- Remanufacturing and Energy SavingsEnvironmental Science & Technology, 2011
- Development of a New Variable Remote Center Compliance (VRCC) With Modified Elastomer Shear Pad (ESP) for Robot AssemblyIEEE Transactions on Automation Science and Engineering, 2005
- Design and Analysis of Remote Center of Compliance StructuresJournal of Robotic Systems, 2003
- Robotic assembly: chamferless peg-hole assemblyRobotica, 1999
- Jamming conditions for multiple peg-in-hole assembliesRobotica, 1998
- The Dynamic Analysis and Design of a High-Speed Insertion Hand Using the Generalized Centroid and Virtual MassJournal of Dynamic Systems, Measurement, and Control, 1990
- Quasi-Static Assembly of Compliantly Supported Rigid PartsJournal of Dynamic Systems, Measurement, and Control, 1982