Direct multi-element analysis of a fluorocarbon polymer via solid sampling-electrothermal vaporization-inductively coupled plasma mass spectrometry
- 22 May 2006
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 21 (9) , 891-898
Abstract
This paper reports on the performance of solid sampling-electrothermal vaporization-inductively coupled plasma mass spectrometry for the direct multi-element analysis of two different perfluorosulfonic acid/TFE copolymer samples, which were selected in order to test the potential of this technique for routine control of fluorocarbon polymers. Careful selection of the most suitable isotopes permits the reliable monitoring of the analytes of interest: Cr, Cu, Fe, K, Mn, Pb and Zn. The use of Pd as chemical modifier allows stabilization of all of these analytes during the pyrolysis step (at 800 °C), enabling adequate matrix removal, while the use of a high vaporization temperature (2700 °C) is required for the efficient simultaneous vaporization of these elements. Moreover, the 105Pd+ signal can be used as internal standard, correcting for possible sensitivity drifts. Under these conditions, straightforward calibration with aqueous standard solutions was feasible for all of the elements investigated. The method thus developed exhibits interesting features, such as a low detection limit (ng g−1 range) for most elements, a high sample throughput (15 min per determination), a low sample consumption (a few milligrams only), precision values usually in the 7–12% RSD range and the absence of any sample pretreatment, with the subsequent lower risk of analyte losses or contamination. Therefore, it seems to offer a promising alternative for the laborious procedures currently in use for analysis of these complex samples.Keywords
This publication has 29 references indexed in Scilit:
- Solid sampling-electrothermal vaporization-inductively coupled plasma mass spectrometry for the direct determination of traces of iodineJournal of Analytical Atomic Spectrometry, 2004
- Correcting sensitivity drift during long-term multi-element signal measurements by solid sampling-ETV-ICP-MSTalanta, 2004
- The use of fluoropolymers to protect semiconductor materialsJournal of Fluorine Chemistry, 2003
- Direct solid sampling with electrothermal vaporization/atomization: what for and how?TrAC Trends in Analytical Chemistry, 2002
- The ETV as a thermochemical reactor for ICP-MS sample introductionJournal of Analytical Atomic Spectrometry, 1999
- Theoretical evaluation of solid sampling-electrothermal atomic absorption spectrometry for screening purposesJournal of Analytical Atomic Spectrometry, 1999
- Discrimination of the causes of imprecision in the direct determination of metals in organic solid samples by electrothermal atomization atomic absorption spectrometryJournal of Analytical Atomic Spectrometry, 1998
- Determination of ultratrace metallic impurities in fluorocarbon polymers by electrothermal atomic absorption spectrometry after decomposition with a combustion systemAnalytica Chimica Acta, 1996
- High purity fluoropolymer materials: Trace element content and leachingJournal of Crystal Growth, 1988
- Interpreting some analytical characteristics of thermal dispersion methods used for sample introduction in atomic spectrometrySpectrochimica Acta Part B: Atomic Spectroscopy, 1988