Mathematical simulation of wet spinning coagulation process: Dynamic modeling and numerical results
- 12 July 2016
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 62 (9) , 3432-3440
Abstract
A dynamic model of polymer wet spinning coagulation process is proposed in this article. The model is based on the double diffusion phenomenon, phase separation process, continuity balance, and momentum balance of the entire coagulation process. The uniqueness of the model lies in its dynamic feature. The model can simulate the system's dynamic response to variations in system inputs/parameters. Steady‐state system solutions can also be produced as the long‐time solutions of the dynamic model; a settling time can be observed at the same time. This paper employs a computationally efficient method of lines numerical algorithm for solving the dynamic model. A simulation experiment on a selected non‐solvent‐solvent‐polymer ternary system is carried out to verify the model as well as the numerical method. The dynamic simulation results are analyzed and discussed. At the end of the article, h‐refinement and p‐refinement are used to confirm the spatial convergence of the numerical solutions. © 2016 American Institute of Chemical Engineers AIChE J, 62: 3432–3440, 2016Keywords
This publication has 13 references indexed in Scilit:
- Two‐dimensional modeling of polymer wet spinning: The effects of mass transfer dynamics on structural propertiesJournal of Applied Polymer Science, 2014
- Effect of Bath Concentration on Coagulation Kinetics at the Early Stage during Wet Spinning of PAN Copolymer Nascent FibersJournal of Macromolecular Science, Part B, 2011
- Influence of sulfuric acid bath on morphological structure and mechanical properties of poly(p-phenylene-1,3,4-oxadiazole) fibersJournal of Applied Polymer Science, 2009
- Study on the Coagulation Process of Polyacrylonitrile Nascent Fibers during Wet-spinningPolymer Bulletin, 2006
- Study on the Coagulation Mechanism of Wet-Spinning PAN FibersJournal of Polymer Research, 2006
- DRYING BEHAVIOR OF ACETATE FILAMENT IN DRY SPINNINGDrying Technology, 2001
- Modeling and Simulation of the Coagulation Process of Poly(acrylonitrile) Wet-SpinningIndustrial & Engineering Chemistry Research, 1996
- Analysis of nonsolvent–solvent–polymer phase diagrams and their relevance to membrane formation modelingJournal of Applied Polymer Science, 1986
- Fundamental analysis of the dynamics, mass transfer, and coagulation in wet spinning of fibersJournal of Applied Polymer Science, 1981
- A study of fiber extrusion in wet spinning. I. Experimental determination of elongational viscosityJournal of Applied Polymer Science, 1970