Orthophosphate Removal from a Synthetic Wastewater Using Lime, Alum, and Ferric Chloride
Authors:
- 1 May 1987
- journal article
- research article
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 22 (5) , 1471-1501
Abstract
Lime, alum, and ferric chloride were evaluated using a series of jar tests to determine their effectiveness in Orthophosphate precipitation from synthetic wastewaters. Calcium phosphate precipitation was most efficient at pH 11.0 and a total carbonate to phosphorus, CT:P, molar ratio of 15.0. For these conditions, a residual total Orthophosphate concentration of 0.12 mg/L-P was observed. The Mg:P molar ratio had little effect on Orthophosphate removal from the synthetic wastewater. When alum was used, the minimum residual total Orthophosphate concentration observed was 0.21 mg/L-P for an A1:P molar ratio of 3.0 and a pH of 6.0 when pH was adjusted before and during alum addition. When ferric chloride was used, it was found that an Fe:P molar ratio of 3.0 and a pH of 6.0 resulted in the lowest residual total Orthophosphate concentration. This value was 0.19 mg/L-P when pH was adjusted before and during iron addition. A multiple regression analysis produced mathematical relationships which can be used to predict residual soluble and residual total Orthophosphate concentration for lime, alum, and ferric chloride treatmentKeywords
This publication has 3 references indexed in Scilit:
- RESPONSE SURFACE EXPERIMENTATIONJournal of Food Processing and Preservation, 1982
- Comparison of iron(III) and aluminum in precipitation of phosphate from solutionWater Research, 1976
- Effects of carbonate and magnesium on calcium phosphate precipitationEnvironmental Science & Technology, 1971