Structural and optical properties of thin zirconium oxide films prepared by reactive direct current magnetron sputtering
- 18 September 2002
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 92 (7) , 3599-3607
Abstract
Thin films of zirconium oxide have been deposited onto glass and Si(100) substrates at room temperature by reactive dc magnetron sputtering of a metallic Zr target in an argon–oxygen atmosphere. The films were characterized by Rutherford backscattering spectroscopy, x-ray diffraction, x-ray reflectometry, atomic force microscopy, and optical spectroscopy to investigate the variation of stoichiometry, structure, density, and optical properties upon increasing oxygen partial pressure. The Zr target shows a well-defined hysteresis upon varying the oxygen pressure as determined by quartz crystal microbalance measurements. Rutherford backscattering experiments reveal that the films are metallic with a small amount of oxygen incorporation at oxygen flows well below 2.7 sccm. Stoichiometric films, however, are formed above 2.8 sccm flow (oxidic mode). Grazing angle incidence x-ray diffraction studies show that crystalline films with monoclinic structure grow in this oxygen flow regime. X-ray reflectivity studies determine a constant density of 6.5 and a deposition rate of approximately 1.5 nm/s in the metallic mode. The transition to the oxidic mode is accompanied by a decrease of film density and a reduction in deposition rate to below 0.2 nm/s for a constant cathode current of 900 mA. In this oxygen flow regime a density of 5.2 is determined, which is approximately 90% of the bulk density of monoclinic With increasing flow in the oxidic sputtering regime the surface roughness of the films increases as is also confirmed by atomic force microscopy. For these flow rates fully transparent films are grown. From measurements of the optical transmittance and reflectance we have determined the optical constants such as the band gap refractive index n, and extinction coefficient k as well as the film thickness. While the refractive index of the films decreases upon increasing flow, the band gap increases simultaneously from 4.52 to 4.67 eV.
Keywords
This publication has 30 references indexed in Scilit:
- Toward solid-state switchable mirrors using a zirconium oxide proton conductorSolid State Ionics, 2001
- Highly conformal ZrO2 deposition for dynamic random access memory applicationJournal of Applied Physics, 2001
- Materials characterization of ZrO2–SiO2 and HfO2–SiO2 binary oxides deposited by chemical solution depositionJournal of Applied Physics, 2001
- Electrical and reliability characteristics of ZrO2 deposited directly on Si for gate dielectric applicationApplied Physics Letters, 2000
- Characterisation of ZrO2 films prepared by rf reactive sputtering at different O2 concentrations in the sputtering gasesVacuum, 2000
- Hafnium and zirconium silicates for advanced gate dielectricsJournal of Applied Physics, 2000
- Advanced characterization tools for thin films in low-E systemsThin Solid Films, 1999
- Structural properties and quasiparticle band structure of zirconiaPhysical Review B, 1998
- Structural Properties of Yttria‐Stabilized Zirconia Films Grown on Silicon (001) Using MOCVDChemical Vapor Deposition, 1997
- Optical properties and environmental stability of oxide coatings deposited by reactive sputteringApplied Optics, 1993