Maskless Lift-Off Microfabrication via Direct Femtosecond-Laser Patterning of PMMA
Preprint
- 1 September 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Polymethyl methacrylate (PMMA) is an attractive candidate for using as a masking layer in microelectronic fabrication, offering advantages such as excellent film uniformity, low cost and easy removal using common solvents like acetone. In this study, we explore the suitability of PMMA as a versatile lift-off mask that can be directly patterned by femtosecond laser irradiation, eliminating the need for conventional photolithographic processes. This method removes the requirement for a developer step in photolithography, thereby streamlining the patterning process. PMMA films of varying thickness were prepared by spin coating on silicon substrates and subjected to controlled femtosecond laser exposure to selectively remove the polymer in defined regions. The influence of film thickness and number of laser beam passes on trench morphology, edge integrity and completeness of PMMA removal was systematically investigated. We demonstrate that thinner PMMA layers facilitate more efficient laser ablation, yielding clean trenches with minimal edge delamination, while multiple laser passes enable complete polymer removal. The patterned PMMA layers were successfully employed as lift-off masks, highlighting their potential in microelectronic and photonic device fabrication. This work underscores the effectiveness of PMMA as a femtosecond laser patternable, solvent removable masking material, providing a simplified and flexible route for high resolution microfabrication. A proof-of-concept for this method was carried out by fabricating Transfer Length Measurement (TLM) contacts over n-type silicon wafer with silver to measure the contact resistance.Keywords
This publication has 25 references indexed in Scilit:
- Influence of the target temperature on Si femtosecond laser surface structuringApplied Surface Science, 2026
- A review on mechanical micro-machining of polymeric materialsJournal of Manufacturing Processes, 2026
- Periodic surface structure formation on silicon surfaces by irradiation of single and multiple femtosecond laser pulsesApplied Surface Science Advances, 2026
- Optimizing repetition rate and fluence for improved groove depth in femtosecond laser processing of siliconJournal of Materials Research and Technology, 2025
- Advanced non-contact Raman/spectrophotometric deciphering of structural processes in sulfur-implanted/laser-annealed siliconMaterials Science in Semiconductor Processing, 2025
- Raman spectroscopic characterization of femtosecond Laser ablation of Silicon in air and liquid mediumApplied Surface Science, 2025
- Method of contact resistivity measurements at typical operating conditions for silicon heterojunction solar cellsSolar Energy Materials and Solar Cells, 2025
- Contact and Bulk Resistivity Screening for Advanced Crystalline Silicon Solar Cell Concepts by an Economical and Reliable Transfer Length Measurement Method Based on Laser Micro‐PatterningPhysica Status Solidi (a), 2020
- Effects of dopant type and concentration on the femtosecond laser ablation threshold and incubation behaviour of siliconApplied Physics A, 2016
- Dynamic response of thin films on substrates subjected to femtosecond laser pulsesActa Materialia, 2015