A quadruple precision and dual double precision floating-point multiplier
Authors:
- M.J. SchulteMSM.J. Schulte
- 1 January 2003
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 76-81
Abstract
Double precision floating-point arithmetic is inadequate for many scientific computations. This paper presents the design of a quadruple precision floating-point multiplier that also supports two parallel double precision multiplications. Since hardware support for quadruple precision arithmetic is expensive, a new technique is presented that requires much less hardware than a fully parallel quadruple precision multiplier. With this implementation, quadruple precision multiplication has a latency of three cycles and two parallel double precision multiplications have a latency of only two cycles. The design is pipelined so that two double precision multiplications can be started every cycle or a quadruple precision multiplication can be started every other cycle.Keywords
This publication has 10 references indexed in Scilit:
- Efficient implementation of rounding units2003
- The S/390 G5 floating point unit supporting hex and binary architectures2003
- Rounding algorithms for IEEE multipliers2003
- A dual mode IEEE multiplier2002
- Algorithms for quad-double precision floating point arithmetic2002
- Using Accurate Arithmetics to Improve Numerical Reproducibility and Stability in Parallel ApplicationsThe Journal of Supercomputing, 2001
- A microprocessor with a 128-bit CPU, ten floating-point MAC's, four floating-point dividers, and an MPEG-2 decoderIEEE Journal of Solid-State Circuits, 1999
- Flagged prefix adder for dual additions1998
- Parallel reduced area multipliersJournal of Signal Processing Systems, 1995
- What Do We Need Beyond IEEE Arithmetic ?1990