Estimating PM Emission Factor from Coal-Fired Power Plants in Korea
Authors:
- Kee-Won JangKJKee-Won Jang
- Hyoung-Chun KimHKHyoung-Chun Kim
- Yong-Mi LeeYLYong-Mi Lee
- Deok-Jong SongDSDeok-Jong Song
- No-El JungNJNo-El Jung
- Sang-Kyun KimSKSang-Kyun Kim
- Ji-Hyung HongJHJi-Hyung Hong
- Suk-Jo LeeSLSuk-Jo Lee
- Jong-Su HanJHJong-Su Han
- 31 October 2011
- journal article
- Published by Korean Society for Atmospheric Environment in Journal of Korean Society for Atmospheric Environment
- Vol. 27 (5) , 485-493
Abstract
Estimating PM Emission Factor from Coal-Fired Power Plants in Korea Coal-fired plant;Emission;Emssion factor;CAPSS;CleanSYS; In Korea, PM (Particulate Matter) emissions caused by coal-fired power plants are measured by a system, so called Clean Air Policy Support System (CAPSS), which uses foreign emission factors. However, the system fails to reflect the characteristics of domestic power plants. In this regard, this study aims to develop local, accurate domestic emission factors. The study measured the amount of TSP (Total Suspended Particulates), PM10 and PM2.5 by collecting samples from the latter parts of pollution control devices which were installed at 3 bituminous-fired power plants and 3 anthracite-fired power plants. The results showed that the average concentrations of TSP, PM10 and PM2.5 measured at bituminous-fired power plants were 4.63 mg/$Sm^3$, 2.96 mg/$Sm^3$ and 3.07 mg/$Sm^3$ respectively, much higher than those from anthracite-fired power plants (2.96 mg/$Sm^3$, 2.47 mg/$Sm^3$ and 1.37 mg/$Sm^3$, respectively). In addition, bituminous-fired power plants showed higher ratios of PM10/TSP and PM2.5/TSP with 0.66 and 0.92, respectively, compared to 0.82 and 0.46, the ratios of PM10/TSP and PM2.5/TSP measured in anthracite-fired power plants. Emission factors based-on concentration measurements were also higher for bituminous-fired power plants, and PM with smaller particles tended to have bigger difference in emission factors between the two fuels. This study calculated the amount of PM emissions by using the estimated emission factors. When it comes to the PM emissions, it was less than that of CAPSS while similar to that of CleanSYS in its amount. It is expected that the emission factors developed by this study will be used in Korea replacing foreign emission factors currently used in Korea by ensuring the objectivity and reliability as domestic emission factors.Keywords
This publication has 7 references indexed in Scilit:
- Emission Characteristics of PM and PM2.5 from Bituminous Coal Combustion Power PlantsJournal of Korean Society for Atmospheric Environment, 2010
- Establishment of a database of emission factors for atmospheric pollutants from Chinese coal-fired power plantsAtmospheric Environment, 2010
- A Study on the Comparison of Emission Factor Method and CEMS (Continuous Emission Monitoring System)Journal of Korean Society for Atmospheric Environment, 2009
- Source Identification of Ambient Size-by-Size Particulate Using the Positive Matrix Factorization Model on the Border of Yongin and SuwonJournal of Korean Society for Atmospheric Environment, 2009
- Primary air pollutant emissions of coal-fired power plants in China: Current status and future predictionAtmospheric Environment, 2008
- Development of an inventory and temporal allocation profiles of emissions from power plants and industrial facilities in ThailandScience of The Total Environment, 2008
- Atmospheric Aerosol over Vermont: Chemical Composition and SourcesEnvironmental Science & Technology, 2001