Adsorption of cationic dye onto Raphanus seeds: optimization, adsorption kinetics, thermodynamic studies
Authors:
Open Access
- 1 August 2024
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-19
Abstract
Dyes are one of the common contaminants in industrial wastewater. Adsorption is the most widely method which used to treat dye-contaminated water due to their easy use, cost-effectiveness, and their efficiency was high. The aim of this study is the investigating of the utilization of the activated carbon which prepared from Raphanus seeds solid residual (ACRS) as a low cost adsorbent for removing of cationic Methylene Blue dye (MB)from wastewater. measuring the surface area using BET methods and SEM. The FT‒IR and XRD was measured. Different variables (e.g.: initial concentration of the dye, pH, contact time, and dosage) have been studied. Process has been systematically investigated experimentally at (25 ± 1 °C). The % removal of MB reached 99.4% after 90-min MB adsorption (40 mg/L) was observed within 5 min of contact time for the Raphanus seeds solid residual (ACRS) dosage of 4 g/L. MB initial concentration (10 ppm) Raphanus seeds solid residual (ACRS) effectively adsorbed MB (> 99%) over a widely range of pH (from pH 2 to pH 8). However, a swift decline in removal was observed when the pH was set at 7. The results of the adsorption kinetics analysis indicate a strong correlation with the pseudo-second-order model, as evidenced by the high regression coefficients. However, the adsorption capacity diminished with a rise in temperature. Thermodynamic calculations of (MB) onto Raphanus seeds solid residual (ACRS) is an exothermic reaction. The results have been indicated that the effectiveness of MB removal by activated carbon prepared from Raphanus seeds solid residual is favorable under neutral conditions, Raphanus seeds solid residual (ACRS) can be considered an efficient, environmentally friendly, readily available, and economical adsorbent that could treat industrial wastewater contaminated with cationic textile dyes. The objective of the experiments was to investigate the impact of various factors on the response of a process or formulation. To accomplish this goal, response surface methodology (RSM) has employed as a statistical model. RSM is an efficient and effective method for optimizing processes through the use of a quadratic polynomial model. The utilization of RSM allows for a reduction in the number of experiments needed, thus minimizing the associated costs of extensive analysis. This method has been done using Box–Behnken Design (BBD) to optimize % removal of MB. The optimal conditions as obtained from the RSM is pH 7,contact time 120 min, initial concentration 10 ppm, ACRS dosage 1 g, adsorption temperature 45 °C.Keywords
Funding Information
- Tanta University
This publication has 28 references indexed in Scilit:
- A unique, inexpensive, and abundantly available adsorbent: composite of synthesized silver nanoparticles (AgNPs) and banana leaves powder (BLP)Heliyon, 2022
- Comparative analysis of pore structure parameters of coal by using low pressure argon and nitrogen adsorptionFuel, 2022
- Adsorption isotherm, kinetic, and optimization studies for copper (II) removal from aqueous solutions by banana leaves and derived activated carbonSouth African Journal of Chemical Engineering, 2022
- Synthesis of modified PANI/CQDs nanocomposite by dimethylgyloxime for removal of Ni (II) from aqueous solutionSurfaces and Interfaces, 2021
- Removal of iron, zinc, and nickel-ions using nano bentonite and its applications on power station wastewaterHeliyon, 2021
- Vibrational spectroscopic, linear and nonlinear optical characteristics of Anthocyanin extracted from blueberryResults in Optics, 2020
- Modelling of growth kinetics of isolatedPseudomonas sp.and optimisation of parameters for enhancement of xanthine oxidoreductase production by statistical design of experimentsJournal of Environmental Science and Health, Part A, 2018
- AMORPH: A statistical program for characterizing amorphous materials by X-ray diffractionComputers & Geosciences, 2018
- Green synthesis of graphene from recycled PET bottle wastes for use in the adsorption of dyes in aqueous solutionEcotoxicology and Environmental Safety, 2017
- Some New Three Level Designs for the Study of Quantitative VariablesTechnometrics, 1960