Buckling of Rectangular Plates with Tapered Thickness
Authors:
- 1 May 1990
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 116 (5) , 1278-1289
Abstract
A power series method with the use of a coordinate transformation has been developed to solve analytically the buckling problem of uniaxially compressed rectangular plates with linearly tapered thickness. The compressed edges are simply supported and the unloaded edges may be arbitrarily restrained, e.g., simply supported, clamped, or free. Accurate buckling loads with rapid convergence are obtained in comparison with other approximate solution methods. The influences of thickness variation, plate aspect ratios, and boundary conditions on the buckling load are shown graphically. The buckling load is highly dependent on the thickness variation. The present exact method is a general one applicable to the buckling and free vibration of the rectangular plates with various thickness variations, although limited to rectangular plates simply supported on two opposite edges.Keywords
This publication has 6 references indexed in Scilit:
- Seminumerical solution for buckling of rectangular platesComputers & Structures, 1986
- Generic buckling curves for specially orthotropic rectangular platesAIAA Journal, 1983
- Buckling of Rectangular Plates With General Variation in ThicknessJournal of Applied Mechanics, 1973
- Buckling of Tapered Rectangular Plates in CompressionAeronautical Quarterly, 1962
- Instability Analysis and Design of an Efficiently Tapered Plate Under Compressive LoadingJournal of the Aeronautical Sciences, 1947
- Beitrag zur Knickung der Rechteckplatte von quadratisch veränderlicher SteifigkeitArchive of Applied Mechanics, 1939