Strain Situation after Fixation of Three-Unit Ceramic Veneered Implant Superstructures
Authors:
- Silke RöschSRSilke Rösch
- Friedrich GraefFGFriedrich Graef
- Thomas D. TaylorTTThomas D. Taylor
- Siegfried M. HeckmannSHSiegfried M. Heckmann
- 1 June 2005
- journal article
- Published by Wolters Kluwer Health in Implant Dentistry
- Vol. 14 (2) , 157-165
Abstract
The passive fit of superstructures used in implant prosthodontics is affected by several variables. The objective of this study was to quantify the strain development in various fixed partial dentures (FPDs), both in the condition as cast and after ceramic veneering. Five different types of three-unit FPDs (cementable/repositioning technique impression; cementable/pick-up technique impression; screw-retained/plastic cylinder; screw-retained/gold cylinder; screw-retained/bonded) with 10 samples each, representing commonly used FPD-types, were investigated before and after ceramic veneering. Two ITI implants were anchored in a measurement model simulating a real-life patient situation and strain gauges were mounted close to the implants. The strain development was recorded during cement setting and screw fixation. For statistical analysis, multivariate two-sample tests were performed with the level of significance set at P = 0.1. All FPDs revealed measurable amounts of strain. Neither the impression technique nor the fabrication modes for conventional screw-retained FPDs had a significant influence on strain development. Ceramic veneering caused an increase in strain development for the conventional bridge types. Furthermore, cementing appears to be able to compensate fabrication inaccuracies better than screw retention. The lowest strains were found in FPDs bonded to gold cylinders on the measurement model for metal frames and ceramic-veneered FPDs. Conventional procedures are unable to produce superstructures with an absolute passive fit. The technique of bonding superstructures to prefabricated components in the oral cavity seems to compensate for various shortcomings in superstructure fabrication.Keywords
This publication has 15 references indexed in Scilit:
- An in vitro study on compensation of mismatch of screw versus cement‐retained implant supported fixed prosthesesClinical Oral Implants Research, 2000
- Evaluation of impression accuracy for osseointegrated implant supported superstructuresThe Journal of Prosthetic Dentistry, 2000
- In vitro comparison of master cast accuracy for single-tooth implant replacementThe Journal of Prosthetic Dentistry, 2000
- A comparison of the dimensional accuracy of the splinted and unsplinted impression techniques for the Bone-Lock implant systemThe Journal of Prosthetic Dentistry, 1997
- An in vivo quantitative analysis of the fit of Nobel Biocare implant superstructuresJournal of Oral Rehabilitation, 1996
- Comparison of Strains Transferred to a Bone Simulant Between As‐Cast and Postsoldered Implant Frameworks for a Five‐Implant‐Supported Fixed ProsthesisJournal of Prosthodontics, 1996
- Comparison of Strains Transferred to a Bone Simulant Among Implant Overdenture Bars with Various Levels of MisfitJournal of Prosthodontics, 1995
- A comparative analysis of the accuracy of implant transfer techniquesThe Journal of Prosthetic Dentistry, 1993
- Evaluation of three impression techniques for osseointegrated oral implantsThe Journal of Prosthetic Dentistry, 1993
- An evaluation of impression techniques for osseointegrated implantsThe Journal of Prosthetic Dentistry, 1990