Effect of adhesive resin flexibility on enamel fracture during metal bracket debonding: anex vivostudy
Open Access
- 29 December 2014
- journal article
- research article
- Published by Oxford University Press (OUP) in European Journal of Orthodontics
- Vol. 37 (5) , 550-555
Abstract
To test the null hypothesis that neither the flexural properties of orthodontic adhesive resins nor the enamel pre-treatment methods would affect metal bracket debonding behaviours, including enamel fracture. A dimethacrylate-based resin (Transbond XT, TX) and two methyl methacrylate (MMA)-based resins (Super-Bond C&B, SB; an experimental light-cured resin, EXP) were tested. Flexural strength and flexural modulus for each resin were measured by a three-point-bending test. Metal brackets were bonded to human enamel pretreated with total-etch (TE) or self-etch adhesive using one of the three resins (a total of six groups, n = 15). After 24 hours of storage in water at 37°C, a shear bond strength (SBS) test was performed using the wire loop method. After debonding, remaining resin on the enamel surfaces and occurrence of enamel fracture were assessed. Statistical significance was set at P < 0.05. The two MMA resins exhibited substantially lower flexural strength and modulus values than the TX resin. The mean SBS values of all groups (10.15–11.09MPa) were statistically equivalent to one another ( P > 0.05), except for the TE-TX group (13.51MPa, P < 0.05). The two EXP groups showed less resin remnant. Only in the two TX groups were enamel fractures observed (three cases for each group). The results were drawn only from ex vivo experiments. The hypothesis is rejected. This study suggests that a more flexible MMA resin is favourable for avoiding enamel fracture during metal bracket debonding.Keywords
This publication has 29 references indexed in Scilit:
- Effect of flexural strength of orthodontic resin cement on bond strength of metal brackets to enamel surfacesEuropean Journal of Orthodontics, 2010
- Bond failure rates with a self-etching primer: A randomized controlled trialAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2009
- Use of Flowable Composites for Orthodontic Bracket BondingThe Angle Orthodontist, 2008
- Development of an Easy-debonding Orthodontic Adhesive using Thermal HeatingDental Materials Journal, 2007
- Influence of polymerization mode on flexural properties of esthetic resin luting agentsThe Journal of Prosthetic Dentistry, 2005
- Bonding durability between orthodontic brackets and human enamel treated with megabond self-etching primer using 4-META/MMA-TBB resin cement.Dental Materials Journal, 2004
- Effect of a self-etch primer/adhesive on the shear bond strength of orthodontic bracketsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2001
- A comparison of the stresses developed in tension, shear peel, and torsion strength testing of direct bonded orthodontic bracketsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1997
- Effect of adding ethylene glycol dimethacrylate to resin cements: durability against thermal stress of adhesion to titanium.Dental Materials Journal, 1997
- Failure at the dental adhesive—etched enamel interfaceJournal of Oral Rehabilitation, 1974