Effect of Thermomechanical Processing on Forming Limit Diagrams Predicted by Neural Networks
Authors:
- 30 October 2008
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 23 (8) , 829-833
Abstract
In the present work, an artificial neural network (ANN) model was developed for predicting the effect of thermo-mechanical processing on the forming limit diagram (FLD) of low carbon steels. The model introduced here considers the content of carbon, the hot finishing temperature, the degree of cold work, the work hardening exponent, the initial yield stress and the ASTM grain size as inputs; while, the predicted FLDs are presented as outputs. The results show that the predicted FLDs by the ANN model are very accurate exhibiting the maximum error of 9% over the whole strain region. The model predicted that with increasing the degree of cold rolling before annealing, the drawability is increased; whereas, the stretchability is decreased. With decreasing the cold reduction, both the predicted and experimental FLD0 values shift to higher strain limits. Besides, the higher the hot finishing temperature, the higher the strain limits of the predicted FLDs will be.Keywords
This publication has 14 references indexed in Scilit:
- A crystal plasticity based estimate for forming limit diagrams from textural inhomogeneitiesJournal of Materials Processing Technology, 2005
- Review of theoretical models of the strain-based FLD and their relevance to the stress-based FLDInternational Journal of Plasticity, 2004
- Analysis of forming limits using ductile fracture criteriaJournal of Materials Processing Technology, 2004
- Proposing a better forming limit diagram prediction: a comparative studyJournal of Materials Processing Technology, 2003
- Prediction of forming limits for anisotropic sheets containing prolate ellipsoidal voidsInternational Journal of Mechanical Sciences, 2003
- A more general model for forming limit diagrams predictionJournal of Materials Processing Technology, 2002
- Computational prediction of the localized necking in sheet forming based on microstructural material aspectsComputational Materials Science, 1998
- Prediction of the forming limit diagrams in pulsatory strainingJournal of Materials Processing Technology, 1994
- Criterion and mode of the forming limit in sheet formingJournal of Materials Processing Technology, 1992
- Prediction of the forming limit diagrams of anisotropic sheets in linear and non-linear loadingMaterials Science and Engineering, 1985