Effect of Ceramic and Metallic Reinforcement on Mechanical, Corrosion, and Tribological Behavior of Aluminum Composite by Adopting Design of Experiment Through Taguchi Technique
- 10 April 2018
- journal article
- research article
- Published by ASME International in Journal of Tribology
- Vol. 140 (5)
Abstract
An attempt has been made to develop and study the properties and behavior of structure-based aluminum composite. Aluminum (AA6063)-based composites were fabricated by stir casting technique (also known as liquid metallurgy route) by varying weight percentage of metallic-based copper nitrate Cu (NO3)2 with fixed proposition of ceramic-based silicon nitride (Si3N4) reinforcement. The mechanical and corrosion properties and tribological behavior of composite were studied. Further, the sample microstructure and characterizations were investigated by scanning electron microscope (SEM) and X-ray diffraction (XRD) technique. The composite with fixed weight proportion of ceramic and higher metallic reinforced samples shows higher tensile strength, improved corrosion resistance, and higher hardness behavior. Due to higher hardness nature, the tribological properties of composite such as wear rate and coefficient of friction have been reduced. Moreover, the impact strength of composite decreased due to combination of ceramic and metallic reinforcement. In addition to the above study, design of experiment (DOE) was adopted to optimize the major wear test parameters such as percentage of reinforcement, applied load, sliding distance, and sliding speed. Finally, analysis of variance (ANOVA) was carried out to identify the most significant test parameter and its interaction affecting wear behavior and its coefficient of friction of composite sample.Keywords
This publication has 37 references indexed in Scilit:
- Investigation of impact behaviour of aluminium based SiC particle reinforced metal–matrix compositesComposites Part A: Applied Science and Manufacturing, 2007
- Influence of stirring speed and stirring time on distribution of particles in cast metal matrix compositeJournal of Materials Processing Technology, 2006
- Optimization of testing parameters on the wear behaviour of metal matrix composites based on the Taguchi methodMaterials Science and Engineering: A, 2005
- Production and mechanical properties of Al2O3 particle-reinforced 2024 aluminium alloy compositesJournal of Materials Processing Technology, 2005
- Abrasive wear behavior and mechanical properties of Al–Si/SiC compositesWear, 2004
- Effect of SiC particle reinforcement on the unlubricated sliding wear behaviour of ZA-27 alloy compositesWear, 1997
- Effects of process parameters on the properties of squeeze-cast SiCp-6061 Al metal-matrix compositeMaterials Science and Engineering: A, 1996
- Microstructure and tensile properties of L12—Type NiCrAl alloy prepared by vacuum plasma spray formingScripta Metallurgica et Materialia, 1995
- Use of spray techniques to synthesize particulate-reinforced metal-matrix compositesJournal of Materials Science, 1992
- Toughening of Thermally Sprayed CoatingsMaterials Science Forum, 1988