A Reaction-Based Stabilizer for Nonmodel-Based Vibration Control of Cable-Driven Parallel Robots
- 29 October 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Robotics
- Vol. 37 (2) , 667-674
Abstract
Considering a simplified model of cables is an essential assumption in the design of state-estimator and vibration control of cable-driven parallel robots (CDPRs). Such an assumption however, impacts the effectiveness of controllers and state-estimators in such systems. This article presents a reaction-based stabilizer for nonmodel-based vibration control of CDPRs to address such model dependence. It is proved analytically that by using only three actuators and not involving the cable-connected winches, the proposed stabilizer regulates all undesired vibrations of the platform. It is also shown that the proposed stabilizer needs only the directly measurable position and velocity of its actuators to form its closed-loop control feedback signals. Effectiveness of the proposed system is more significant in CDPRs with considerable nonlinear effects of cables, where such effects are computationally costly to model, such that the performance of real-time controllers and state-estimators are spoiled. To provide a case study, a multibody nonlinear dynamic model of a suspended CDPR equipped-with the proposed stabilizer with zero cable damping effects is developed in SimMechanics/MATLAB, where a fine-tuned proportional-derivative controller is applied on each actuator to suppress all vibrations of the system. In addition, a suspended CDPR with extremely stretchable nonlinear-stiffness elastomer cables is fabricated and tested, where performance of the proposed stabilizer to suppress the high-amplitude nonlinear oscillations of the whole system is demonstrated.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 17 references indexed in Scilit:
- Kinematically-Constrained Redundant Cable-Driven Parallel Robots: Modeling, Redundancy Analysis, and Stiffness OptimizationIEEE/ASME Transactions on Mechatronics, 2016
- Adaptive Vibration Control of a Flexible Cable Driven Parallel RobotIFAC-PapersOnLine, 2015
- Dynamic Modeling and Noncollocated Control of a Flexible Planar Cable-Driven ManipulatorIEEE Transactions on Robotics, 2014
- Active vibration canceling of a cable-driven parallel robot using reaction wheels2014
- Dynamic Modeling and Control of Parallel Robots With Elastic Cables: Singular Perturbation ApproachIEEE Transactions on Robotics, 2014
- Dynamic modeling and wind vibration control of the feed support system in FASTNonlinear Dynamics, 2011
- Dimensional Optimization Design of the Four-Cable-Driven Parallel Manipulator in FASTIEEE/ASME Transactions on Mechatronics, 2009
- Dynamic modeling and active control of a cable-suspended parallel robotMechatronics, 2008
- Cable suspended planar robots with redundant cables: controllers with positive tensionsIEEE Transactions on Robotics, 2005
- Dynamics/Control of a Radio Telescope Receiver Supported by a Tethered AerostatJournal of Guidance, Control, and Dynamics, 2002