EMI Coupling Paths and Mitigation in a Board-to-Board Connector
Authors:
- 24 June 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 57 (4) , 771-779
Abstract
Cage connectors for optical subassembly I/O modules have been identified as one of the main coupling paths in an optical link at the front-end of switches and routers. In the study presented herein, the simulation model used to study electromagnetic interference coupling physics and mitigation of the optical cage connector was corroborated by comparing the measured and simulated results for the total radiated power (TRP). Currents on the adjacent ground references to the differential signal conductors caused half-wave resonant peaks in the TRP response in the frequency range of 4-18 GHz. At frequencies from 18 to 28 GHz, both full-wave simulation and analytical formulas indicate that the radiation results primarily from the currents on the signal traces. The radiation from the optical cage connector was suppressed with absorbing materials, and the coupling path was verified, together with the optical cage and module enclosure.Keywords
Funding Information
- National Science Foundation (IIP-1440110)
This publication has 22 references indexed in Scilit:
- Radiation physics and EMI coupling path determination for optical links2014
- Radio-frequency interference mitigation strategies for high-speed connectors2013
- High-frequency EMC design verification through full-wave simulations and measurements in Reverberation Chamber2013
- The effect of various skew compensation strategies on mode conversion and radiation from high-speed connectors2013
- The EMI characteristics of High Speed backplane connector2012
- An analytical approximation for evaluating impact of skew length on radiated emission from differential signal pairs2012
- Electromagnetic Fields in Cavities2009
- EM emission of differential signals across connected printed circuit boards in the GHz range2009
- On the Measurement of Total Radiated Power in Uncalibrated Reverberation ChambersIEEE Transactions on Electromagnetic Compatibility, 2007
- Backplane Connector Radiated Emission And Shielding Effectiveness1992