Dentin bonding: effect of tubule orientation on hybrid‐layer formation
Authors:
- 1 August 1997
- journal article
- research article
- Published by Wiley in European Journal of Oral Sciences
- Vol. 105 (4) , 344-352
Abstract
Schüpbach P. Krejci I, Felix L: Dentin bonding: effect of tubule orientation on hybrid‐layer formation.In an attempt to compare the morphology of the resin‐dentin interface in areas where the dentinal tubules run perpendicularly or at an angle to the cavity surface with that of areas where they run parallel to it, we studied a dentin adhesive system using transmission electron microscopy and fluorescence confocal laser scanning microscopy. The design of the study included the simulation of the normal hydrostatic pressure within the pulp and the dentinal tubules. Following acid etching of the dentinal surface with maleic acid/HEMA, the smear layer was removed, and a superficial zone was demineralized in such a way that the exposed collagenous dentin matrix retained its integrity. Confocal laser scanning microscopal investigations using primer labeled with rhodamine B showed that the penetration of the primer occurred not only vertically via surface porosities, but mainly laterally, via the dentinal tubules. The adhesive resin labeled with fluorescein completely infiltrated the demineralized layer, thereby forming a hybrid layer. The orientation of the dentinal tubules had a profound effect on the formation of the hybrid layer. In areas with perpendicular tubule orientation, the layer was 3.2 ± 0.8 μm thick, showing solid 27.2 ± 0.8 μm long resin tags in the dentinal tubules, and a network of tiny tags in their side‐branches. In areas with parallel tubule orientation, the layer was significantly thinner (1.3 ± 0.6 μm) and resin tags were absent.Keywords
This publication has 12 references indexed in Scilit:
- Scanning Transmission Electron Microscopy/Energy-dispersive Spectroscopy Analysis of the Dentin Adhesive Interface Using a Labeled 2-Hydroxyethylmethacrylate AnalogueJournal of Dental Research, 1995
- Dentinal tubule anastomosis: A potential factor in adhesive bonding?The Journal of Prosthetic Dentistry, 1994
- Morphological characterization of the interface between resin and sclerotic dentineJournal of Dentistry, 1994
- Current Concepts in Dentin Bonding: Focusing on Dentinal Adhesion FactorsThe Journal of the American Dental Association, 1993
- Comparative SEM and TEM Examination of the Ultrastructure of the Resin-Dentin Interdiffusion ZoneJournal of Dental Research, 1993
- Influence of Dentinal Fluid and Stress on Marginal Adaptation of Resin CompositesJournal of Dental Research, 1993
- A confocal microscopic evaluation of the interface between Syntac adhesive and tooth tissueJournal of Dentistry, 1992
- Morphological Aspects of the Resin-Dentin Interdiffusion Zone with Different Dentin Adhesive SystemsJournal of Dental Research, 1992
- Effect of HEMA on bonding to dentinDental Materials, 1992
- Effect of different types of smear layers on dentin and enamel shear bond strengthsDental Materials, 1988